Transcript
Installation and Assembly - Projector Adapter Plate for Sharp™ model PG-M15X and Net TV LCD Projectors
Models: PAP 121, PAP 121-S, PAP 121-W
WARNING
IMPORTANT! Read entire instruction sheet before you start installation and assembly.
• Installer must verify that the ceiling will safely support four times the combined weight of all attached equipment and hardware.
Before you start check the parts list below to make sure all of the parts shown are included.
Parts List Description AA BB CC DD EE FF GG
adapter plate 1/4 - 20 x 3/8" socket pin screw M3 -.5 x 25 mm thumb screw 4 mm allen wrench retaining spacer spacer M3 - .5" x 6 mm phillips pan
Qty.
PAP 121
PAP 121-S
PAP 121-W
1 1 1 1 1 1 1
055-1207 520-1109 560-1139 560-9646 590-1128 590-0108 520-1028
055-4207 520-2109 560-7139 560-9646 590-2128 590-0108 520-2036
055-2207 520-2109 560-7139 560-9646 590-2128 590-0108 520-2036
BB CC
DD EE
GG
Note: Actual parts may appear slightly different than illustrated.
Flip projector upside-down and attach adapter plate (AA) using one socket pin screw (BB) and one phillips screw (GG) as shown. Tighten screw (BB) using 4 mm allen wrench (DD).
AA
FF
*Notch indicates front of projector. Secure adapter plate with thumb screw (CC), spacer (FF) and retaining spacer (EE) in remaining hole.
CC FF AA
BB GG
*
EE
1 of 1 Visit the Peerless Web Site at www.peerlessindustries.com © 2005 Peerless Industries, Inc. All rights reserved. Peerless is a trademark of Peerless Industries, Inc. All other brand and product names are trademarks or registered trademarks of their respective owners
ISSUED: 12-27-01 SHEET #: 055-9073-5 03-09-05
For customer service call 1-800-729-0307 or 708-865-8870.
