Preview only show first 10 pages with watermark. For full document please download

User’s Manual Hdes-100m-8tx/ Sp/ Rx Introduction

   EMBED

Share

Transcript

User’s Manual HDES-100M-8TX/ SP/ RX  CAT5e IN: connect with Transmitter’s CAT5e OUT port using a CAT5e cable, up to 100 meters.  Introduction CAT5e OUT: Connect to Receiver’s CAT5e IN port using a CAT5e cable, up to 100 meters. The HDES-100M is a state-of- the-art HDMI+IR over CAT5e that not only can extend the Full HD 1080p up to 100 meters over a  Power LED: Light on as DC5V power adaptor plugged.  DATA LED: Flash as AV streaming connected up. single CAT5e cable but also support daisy/tree chain to connect one HDMI source with up to 800 displays. ‧Receiver: Installation  HDMI OUT: Connect with the HDMI display.  CAT5e IN: Connect with Transmitter’s or Splitter’s ‧Transmitter: CAT5e OUT port using a CAT5e cable, up to 100  HDMI IN: Connect with HDMI source.  CAT5e OUT: Connect with Receiver’s or Splitter’s meters.  CAT5e IN port using a CAT5e cable, up to 100 meters. IR: Plug in the IR Receiver here, its carrier frequency must support full range 30~50kHz  IR: Plug in the IR Blaster here.  DC5V: Plug in the DC5V power adaptor.  DC5V: Plug in the DC5V power adaptor.  Power LED: Light on as DC5V power adaptor plugged.  Power LED: Light on as DC5V power adaptor plugged.  DATA LED: Flash as AV streaming connected up.  DATA LED: Flash as AV streaming connected up. ‧1-2 Splitter:  HDMI OUT: Connect with the HDMI display.  DC5V: Plug in the DC5V power adaptor. -2- -1- CAT5e Cabling  -3- Pin Assignments: -4-