Transcript
8 CH IP-LINK RECEIVER SUB-RACK
SC-IPR0808
User's Manual 1. Product Components SC-IPR0808
Mount Bracket (2 pcs)
Adapter’s Bracket (8 pcs)
Multi Tap Cord
Cable (3C-2V)
Instruction Manual
Round bolt 4X4 (8EA)
Round bolt 3X6 (16EA)
2. Dimension
0
3. How to assemble the SC-IPR0808 Sub-Rack 1) Fix the two pieces of mount bracket at each side of the sub-rack using the 4x4 round bolts as below.
4X4 round bolt Sub-rack left/right side
Tighten the bolt as above. The head of the bolt should face up to inner side of the rack.
Mount bracket
Fix the rack using the mount bracket
2) Remove the left side cover of SC-IPR0801 (receiver) as below. Fix the SCIPR0801 at the front of the sub-rack using flat headed bolt to the same direction indicated by the arrow. When tighten the receiver use the flat headed bolt of the SC-IPR0801. Please be careful not to miss the 4 pieces of 3x8 flat headed bolt.
SC-IPR0801 (Receiver)
Fix the SC-IPR0801 receiver into the sub-rack to the arrow’s direction.
1
Remove the side cover.
Remove the flat headed bolt (3X8) and keep them aside.
Tighten the receiver using the flat headed bolts
3) Put the power adapter’s bracket at the rear side of the sub-rack and then fix the bracket to the sub-rack using the small 3X6 round bolt. Put the two pieces of power adapter at the adapter’s bracket and then fix the second bracket using the same bolt as below.
Bracket for the power adapter
First, locate the rear side brackets.
Round headed bolt (3X6)
Put two power adapters as indicated the above arrow.
Fix the bracket.
Install the second bracket and fix the adapter
4) Connect the 3 Pin terminal block with the harness cable of the power adapter and then connect the terminal block to the receiver (SC-IPR0801).
+
5) Connect the power cord to the power adapter and then connect the plug of the adapter to the multi tap cord located at the back side of the sub-rack. Finally, tidy up the power cables using the cable ties.
Power cord of the power adapter
Connect the power cord to the adapter
Connect the power plug to the multi tap cord.
2
4. Connection of Cable Coaxial Cable for IP data (3C-2V)
UTP Cable
※ Precaution: Please be careful when connecting the BNC connector. If you apply too much force to the BNC connector of the receiver, it may damage the BNC connect port. ① ② ③ ④
① BNC-F (Coaxial Cable): Connect the SC-IPT0801 (transmitter) using the coaxial cable. ② Green LED: The Green LED is on if the SC-IPT0801 (transmitter) is connected correctly. ③ Power LED - Green: if the power is supplied to the transmitter over the coaxial cable correctly. - Red flickering: if the power is not supplied correctly. ④ RJ-45 Jack (UTP cable): LAN/ WAN or PC(NVR). Connect a LAN/WAN communication device or PC or NVR.
5. Specifications MODEL Max. # of Receiver Dimension
SeeEyes Co.,Ltd
3
8ch Sub-rack / SC-IPR0808 Max. 8 receivers 430(W) ⅹ 66(H) ⅹ 470(D) mm (without the mount bracket)
#502~506, Sunil Technopia, 440, Sangdaewon-Dong, Jungwon-Gu, Sungnam-Si, Gyeonggi-Do, Korea TEL : +82-(0)31-777-3508 FAX : +82-(0)31-777-3512 EMAIL :
[email protected] http://www.sscctv.com/eng
