Transcript
Rev. 060214
REAR-VIEW CAMERA FOR SELECT TOYOTA VEHICLES 2014-UP RVCTY-71L
We recommend reading this installation guide first before starting any work. Following these instructions from “Start” to” Finish” will ensure a smooth and hassle free installation. We offer telephone support M-F 9:00 AM – 5:00 PM PDT at 1 (855) 822-1348. We are here to help.
CAMERA CONNECTIONS
PARTS INCLUDED:
24-PIN
(1) TY-71L Rear Camera (1) 15 ft. Extension (1) Toyota Harness (1) Instruction
TOYOTA 2014 - 2014 Corolla Note: This unit is NOT compatible with “Tech Audio” systems.
TO FACTORY RADIO
TO FACTORY HARNESS
24-PIN
(female plug)
(male plug)
YELLOW RCA
Camera Specifications: - Lens Angle 170 Degrees - Resolution 420 TV Lines - Min. Illumination 0.2Lux - Voltage 12v - Operating Temp. -40 to 80RH - NTSC/ PAL - Reference Lines - Shutter Speed 1/60s - 20us - Waterproof - Pixels 656 x 492
15 ft
(extension)
PRECAUTIONS:
- Remove the negative side of the battery to avoid any short circuits during the installation. - Do not install the interface near any major components or near the HVAC system. This may cause damage or overheating to the vehicle.
4-PIN BARREL CONNECT FOR CAMERA POWER AND SIGNAL
PRELIMINARY:
Please read the entire manual before installing this interface.
INSTALLING THE CAMERA AND INTERFACE
1. Remove the rear panel. 2. Drill a 5/8 size hole in the location 3. Fish the wires through the drilled hole and into the trunk/cargo area. 4. Remove the factory radio to gain access to the factory connectors. connectors. Connect behind the DISPLAY not behind the radio. 6. Route the wires from the camera towards the radio and make the power and video connections. For powering up the camera, use the GREEN 12v output wire from the DATA-Bus interface.
WHITE
(Parking Lines) CONNECT TO TURN OFF
BLUE
(Front/ Rear Camera View) CONNECT TO FOR FRONT
PARKING LINE
The parking lines are there to assist you while reversing. What the lines mean: Yellow Line: CLEAR Purple Line: GETTING CLOSE Red Line: WARNING - VERY CLOSE To remove the parking lines simply cut the WHITE wire located near the 4 pin barrel connector in the truck.
YELLOW
REVERSE TRIGGER (OPTIONAL)
If the vehicle does not provide the reverse trigger input, the installer must insert the female pin (PROVIDED) into the factory 28-Pin connector The reverse can be found at the FUSE PANEL on Driver’s side kick panel.
PIN 2
WHITE
(Reverse Trigger Input)
PIN 7
PURPLE RED
TROUBLE SHOOTING
1. If noise occurs on the screen while vehicle is in reverse, we recommend grabbing the GROUND from PIN-7 on the 10-Pin connector.
(ground)
PIN VIEW
2. IF A CHANGE IS MADE TO EITHER THE WHITE OR GREEN WIRES, PLEASE RESTART THE VEHICLE. TURN OFF THEN BACK ON.
Rev. 060214
REAR-VIEW CAMERA FOR SELECT TOYOTA VEHICLES 2014-UP RVCTY-71L
TOYOTA 2014 - 2014 Corolla Note: This unit is NOT compatible with “Tech Audio” systems.
COMPATIBLE RADIOS: