Vari-focal Dome Camera Color Dome Camera

Transcript

66-CMD052CSE-2 COLOR DOME CAMERA VARI-FOCAL DOME CAMERA Installation 1. Put the provided screws (M3.0 x 25, wooden screw) through the holes marked as "a", and fix the base in the desired area (FIG.1). Instruction a Part Description & Dimension a [CMD052/056 Series] a 120 120 55 40 FIG. 1 102 98 Unit : mm VIDEO OUTPUT JACK DC POWER INPUT (DC12V 10%) JACK DC12V (NON-POLARITY INPUT) OR AC24V POWER INPUT BASE FIX RING INSIDE COVER DOME COVER LENS 2. The direction of the lens is adjustable through the adjustable Pan/Tilt brackets and rotatable round bracket for Azimuth. The lens can be adjusted easily by hand without using screw driver. Please refer to FIG.2 (Board Lens) and FIG.3 (Vari-Focal Lens). BRACKET TILT AZIMUTH PAN FIG. 2 (CMD052/056/152/156) [CMD152/156 Series] 120 IRIS LEVER VR TILT SCREW DRIVER BRACKET ZOOM ADJUSTMENT FOCUS ADJUSTMENT AZIMUTH 55 PAN FIG. 3 (CMD052X/056X/152X/156X) 102 98 VIDEO OUTPUT JACK DC POWER INPUT (DC12V 10%) JACK DC12V (NON-POLARITY INPUT) OR AC24V POWER INPUT BASE FIX RING INSIDE COVER DOME COVER LENS Unit : mm 3. An extra RCA jack for easy installation. Plug the video input of monitor to the RCA jack and adjust focus and zoom. After finished, unplug the RCA jack. Please refer to FIG.4. FIG. 4 4. Adjust DC iris level by turning the iris level VR. Please refer to FIG.3. ATTENTION: Adjust this VR with care so as not to cause damage to the unit. 5. Put on the inside cover first, and followed by put on the dome cover. Then tighten the fix ring(FIG.5). Specifications SUPERHIGH RESOLUTION COLOR DOME CAMERA CMD052 3.6 CMD152 3.6 Model No. 3.6mm Focal Length Lens Angle of View 6.0mm F1.8 H 73 44.5 V 54.5 33.1 D 92 56 DC12V 10% AC24V 10% DC12V 10% Power Input Voltage Internal Sync. Mode Pick Up Element 1/3" Super HAD CCD Sensor Effective Pixels 768(H) x 494(V) [NTSC] 752(H) x 582(V) [PAL] 5.59mm(H) x 4.68mm(V) Chip Size c c 15.734KHz / 59.94Hz [NTSC] 15.625KHz / 50Hz [PAL] Horizontal & Vertical Sync. Frequency Scanning System 2:1 Interlace Resolution 540 TV Lines 0.5 Lux at F1.8 Min. Illumination More than 50dB (AGC-OFF) S/N Ratio 36dB Variable Gain Auto Gain Control ATW White Balance Horizontal , Vertical Aperture Correction 1/60(1/50)S ~ 1/10,000S (Auto) Electrical Shutter Auto Back Light Compensation FIG. 5 =0.45 Gamma Characteristic Power Consumption NOTE Point each "b" to each "c". DC12V 10% AC24V 10% DC12V 10% NTSC or PAL System b CMD052 6 CMD152 6 F2.0 Iris b CMD052 6 CMD152 6 CMD056 3.6 CMD156 3.6 3.0W (DC12V) 2.5W (AC24V) 2.2W (14 ~ 122 ) 120 x 102mm -10 Operating Temperature ~ +50 Dimension Weight 3.0W (DC12V) 2.5W (AC24V) 2.2W 290g 290g 310g 310g Design and specification are subject to change without notice. SUPERHIGH RESOLUTION VARI-FOCAL DOME CAMERA CMD052X4.2 CMD152X4.2 Model No. H Power Input Voltage 4 ~ 9mm F1.6 99.6 ~ 24.9 69 ~ 30.7 V 73.2 ~ 18.8 51 ~ 23 D 128.5 ~ 31.0 86 ~ 38.5 DC12V 10% DC12V 10% AC24V 10% DC12V 10% Internal Sync. Mode Pick Up Element 1/3" Super HAD CCD Sensor Effective Pixels 768(H) x 494(V) [NTSC] 752(H) x 582(V) [PAL] 5.59mm(H) x 4.68mm(V) Chip Size 15.734KHz / 59.94Hz [NTSC] 15.625KHz / 50Hz [PAL] Horizontal & Vertical Sync. Frequency Scanning System 2:1 Interlace Resolution 540 TV Lines 0.07 Lux at F1.6 0.03 Lux at F1.2 More than 50dB (AGC-OFF) S/N Ratio 36dB Variable Gain Auto Gain Control ATW White Balance Horizontal , Vertical Aperture Correction Auto Back Light Compensation =0.45 Gamma Characteristic Power Consumption 2.2W 3.0W (DC12V) 2.5W (AC24V) -10 Operating Temperature 310g 2.2W 3.0W (DC12V) 2.5W (AC24V) (14 ~ 122 ) 120 x 102mm ~ +50 Dimension Weight DC12V 10% AC24V 10% NTSC or PAL System Min. Illumination CMD056X2.2 CMD156X2.2 F1.2 Iris Angle of View CMD052X2.2 CMD152X2.2 2.8 ~ 12mm Focal Length Lens CMD056X4.2 CMD156X4.2 330g Design and specification are subject to change without notice. 310g 330g