Transcript
Press to return to index VARIATION OF STANDARD WIRING DIAGRAMS FOR OPEN VOICE VIDEO DOOR ENTRY SYSTEM VARIATION 87
1st CABLE RISER
2nd CABLE RISER
3rd CABLE RISER
®
4th CABLE RISER
Connection of video distributor type 5556/004 or type 6554 on monitor type 5651, 5652, 5653. The video connection must be made using a RG59 type cable or one similar with an impedance of 75 Ohm. All video outputs V1-V2-V3-V4 must be loaded by 75-Ohm resistors supplied. They must therefore be mounted on unused output terminals or on terminal V2-M of monitor. The last video signal distributor must be loaded by 75-Ohm resistor connected to unused terminal V.
MONITOR TERMINAL BLOCKS
MONITOR TERMINAL BLOCKS
MONITOR TERMINAL BLOCKS
MONITOR TERMINAL BLOCKS
N.B. Trimmer P1 in video signal distributor type 5556/004 can increase video signal gain in every output at the same time. Manufacturer setting 1 gain.
To camera
Mains POWER SUPPLY type 6582
POWER SUPPLY type 6681
DISTRIBUTOR type 6554 type 5556/004
* N.B. Position the shunt in “A-B-D” in power supply type 6582.
*
VARIATION 88
Additional bell type 860A
Wiring diagram of additional electronic ringtone type 860A. N.B. Electronic ringtone type 860A features a two or three-note ringtone which is selected by connection to the corresponding terminal (7 or 8). The ringtone is powered by the mains voltage.
Monitor type 7500
PRI
8 7
CN1
Additional bell type 860A
PRI 1 2 3 4 5 6 8
8 7
5 4
Mains
9 1O 11 12 V1 M V2
5 4
Mains Additional bell type 860A
V2 M V1 1 2 3 4 5 6 7 8
9 10 11 12 13
PRI
8 7
5 4
Mains Phone type 7400
GALILEO
CN1
Monitor type 5651 type 5653
1 2 3 4 5 6 8 9 11 12
209
