Transcript
Specification
VCS 500M10 Combination Wave Generator The combination wave generator type VCS 500M10 generates high voltage transients as required by IEC 61000-4-5, Surge Immunity Requirements. The same transients are used for surge testing as per ITU recommendations for telecom equipment.
emc test equipment
• IEC 61000-4-5
• ITI K44 recommendations
VCS 500M10
Combination Wave Voltage (open circuit) Pulse front time Pulse time to half value Current (short-circuit) Pulse front time Pulse time to half value Polarity Event counter select Pulse counter
Trigger
Automatic Manual External CRO trigger Synchronization Pulse repetition rate
1.2/50µs – 8/20µs 500V – 10,000V ± 10% 1.2µs ± 30% 50µs ± 20% max. 5,000A ± 10% 8µs ± 20% 20µs ± 20% Positive/negative/alternating 1 – 30,000 or endless 1 – 1,000,000
Measurements Peak voltage Peak current
Test Routines
Serial interface Parallel interface
Safety
Safety circuit Warning lamp
General data
Automatic pulse release Single pulse release External pulse release 5V trigger signal for oscilloscope 0° - 360°, resolution 1° 12s - 999s depends on the voltage
Output Direct
Interface
Via HV connector; Zi = 2Ω To connect external surge coupler
10,000V in the LCD display 5,000A in the LCD display
Dimensions, weight Supply voltage Fuses Interfaces
RS 232, baud rate 1200 - 19200 IEEE 488, address 1 - 30
Control input (24Vdc) Floating output contact
19“ / 6HU, approx. 35kg 115/230V +10/-15% 2 x T 2AT (230V) or 2 x T4AT (115V) RS 232 and IEEE 488 (GPIB)
Coupling/Decoupling networks for ac/dc power lines CNI 503A16 CNI 503A18 CNI 503A19 CNI 503A20 CNV 501S4 CNV 503S9 CNV 503S10 CNV 503S11 CNV 503S12
3phase coupler for EFT and Surge; 3x440V/16A 3phase coupler for EFT and Surge; 3x440V/32A 3phase coupler for EFT and Surge; 3x440V/63A 3phase coupler for EFT and Surge; 3x440V/100A 1phase coupler for Surge only; 250V/16A 3phase coupler for Surge only; 3x440V/16A 3phase coupler for Surge only; 3x440V/32A 3phase coupler for Surge only; 3x440V/63A 3phase coupler for Surge only; 3x440V/100A US types are for 3x480V
Coupling/Decoupling networks for signal/telecom lines
Quick Start
Immediate start; easy to use and fast
User Test Routines
Change Polarity after n pulses Change voltage after n pulses by ∆V
Standard Test Routines
IEC 61000-4-5 Level 1,000V IEC 61000-4-5 Level 2,000V IEC 61000-4-5 Level 4,000V Manual Standard Test Routine
Service
Service, setup, self test
CNV 504S1 CNV 504S2 CNV 508S1 CNV 508S2
4 telecom lines as per fig. 12 IEC 61000-4-5 4 signal lines as per fig. 11 IEC 61000-4-5 8 telecom lines as per fig. 12 IEC 61000-4-5 8 signal lines as per fig. 11 IEC 61000-4-5
Pulsed Magnetic Field as per IEC 61000-4-9 Antenna
MS 100 for up to 5,000A/m
Design and technical data subject to change without notice.
EM TEST AG Sternenhofstr. 15 CH-4153 Reinach Switzerland
Tel: Fax: email: URL
+41 (0)61 717 91 91 +41 (0)61 717 91 99
[email protected] http://www.emtest.com
vcs500m10v104.doc 05.11.04 Page 2/2
