Preview only show first 10 pages with watermark. For full document please download

Victorian Freestanding Tub Faucet Installation Instructions

   EMBED

Share

Transcript

VICTORIAN FREESTANDING TUB FAUCET INSTALLATION INSTRUCTIONS Before you begin, read the installation instructions below. Observe all local plumbing and building codes. For the following installation instructions for your new Freestanding Tub Faucet it is assumed that the water supply lines are in place and directly accessible for faucet installation. Unpack and inspect faucet and parts for damage. If any damage is found, contact Customer Service at 1-866-855-2284. If you need assistance while installing your new faucet, call our Customer Service number. We recommend consulting a professional if you are unfamiliar with installing bathroom fixtures and plumbing. Signature Hardware accepts no liability for any damage to the floor, walls, plumbing, or personal injury during installation. Caution: Do not grab or hold on to faucet or risers for support. TOOLS AND MATERIALS: Adjustable Wrench Level Tape Measure Drill Plumber’s Tape INSTALLATION 1. We recommend that the spout of the faucet extend out approximately 3-5" over the interior of the tub. Refer to product details for faucet center and spout reach information. 2. Optional 3", 6" and 9" pipe nipples are provided, allowing for height adjustment. Attach the appropriate length pipe nipple to the water supply at the floor. 3. Thread the shut-off valves onto the pipe nipples and tighten to secure. 4. Wrap plumber's tape around the threads at the bottom of the lower riser sections. Attach the risers to the shut-off valves and tighten to secure. 5. Slide the wall supports onto the risers and secure to the wall with mounting hardware provided. Use a level to verify that the risers and wall supports are properly aligned. 6. Connect any nuts and/or washers and the faucet body to the risers. 7. Close the shut-off valves and turn on the main water supply to check for leaks. If leakage occurs, use an adjustable wrench to tighten the connections as necessary. If problems persist, contact Customer Service at 1-866-855-2284. 8. Turn the hot and cold handles to the “on” position and let water run through the spout for approximately 60 seconds. Check to make sure that all connections are tight (no water should be leaking) and that the hot and cold supplies are working correctly. Victorian Freestanding Tub Faucet Installation Instructions 1