Preview only show first 10 pages with watermark. For full document please download

Video-server_bitcentral(4820dr

   EMBED


Share

Transcript

Bitcentral Bitcentral® Precis™ 6. Press Com Type and use the Type knob to select RS-232. Cable Connections 7. Press Com Settings and use the Baud and Parity knobs to select 38400 (Baud) and ODD (Parity). The device connects to the switcher over an RS-232 serial connection to a DB9 port on the switcher and a DB9 port on the device. 1 2 3 4 5 1 2 3 4 5 6 7 8 9 6 7 8 9 To Switcher To Device (male cable end) (male cable end) 8. Press Extra Options. Option TargetMachine Value Bitcentral Note: The remaining extra options are set automatically when the target machine in selected. Figure 1: Switcher to Precis™ Cable 9. Press HOME > Confirm. ™ Table 1: Switcher to Precis Cable Connections Acuity™ (Remote Port) Precis™ 2 (Tx) 2 (Rx) 3 (Rx) 3 (Tx) 5 (Ground) 5 (Ground) To Set Up a Video Input 1. Press HOME > Setup > Installation > Source Config > Input Type. 2. Use the Input knob to select the input source that you want to configure. 3. In the Input Type area, select VTR. Switcher Setup The switcher must be set up to communicate with the video server using either serial or ethernet protocols, as well as associate the video inputs that are coming into the switcher from the video server with the channel on the device that they are coming from. Note: If you are using multiple video channels, each channel should be assigned to a separate port, or a port expander should be used. To Set Up Communications 1. Press HOME > Setup > Installation > Com Setup. 2. Press Type and use the Com Port knob to select the remote port that you want to set up for the device. 3. Use the Device knob to select VTR (CLIP). 4. Press Select Device and use the Device knob to select VDCP. 4. Press More > VTR/VDCP Xpts and use the Controller knob to select the device that the video signal is coming from. 5. Press VDCP Setup and use the Channel and SubAddress knobs to select the video output channel you are controlling on the device (channel) and 0 (sub-address). 6. Press HOME > Confirm. Troubleshooting If the device is communicating properly, but you cannot gain control from the switcher, try cycling through different values for the SubAddress, and then the Channel. The most common settings are channel set to the video channel number and sub-address set to 0 or and channel set to the video channel number and sub-address set to the serial communications port on the video server. 5. Use the VTR Preroll knob to select 0. 4820DR-664 Rev.1