Transcript
Camera Specifications Image Sensor
High Resolution 1/4” Sensor
Video Format / Pixels
NTSC: 656(H) x 492 (V)
Horizontal Resolution
480 TVL
Sync. & Scan. Systems
Internal; 2:1 Interlace
S/N Ratio
48dB
Iris & Shutter Speed
AES; 1/60 ~ 1/50,000 sec.
Minimum Illumination
3.0 LUX
Video Output
Comp. 1.0 Vpp @ 75ohm
Lens / Lens Mount
3.6 mm F2.0/ Fixed
FOV (diagonal)
73 Degrees
Termination
Video: BNC Female Power: Barrel Female
IR / Night Vision Range
N/A
Power Requirement
12V DC
Power Consumption
100 mA max
Operating Temp.
14°F ~ 122°F (-10°C ~ 50°C)
Weight (with stand)
0.50 lbs / 0.23 kg
Dimensions LxWxH (with dome)
4.7” x 4.7” x 3.3” 118 mm x 118 mm x 83 mm
Dimensions:
IT’S ALL ON THE WEB! Product Information
Specification Sheets
User Manuals
Software Upgrades
Quick Start Guides
Firmware Upgrades
VISIT www.digimerge.com
HIGH RESOLUTION 3-AXIS COLOR DOME CAMERA MODEL: DBD13
QUICK START GUIDE English Version 1.0
Digimerge Technologies Inc. Copyright © 2010 Digimerge Technologies Inc. As our products are subject to continuous improvement, Digimerge reserves the right to modify product design, specifications and prices, without notice and without incurring any obligation. E&OE
www.digimerge.com Copyright © 2010 Digimerge Technology Inc.
Contents
1 x Mini Color Dome Camera
Installing the camera
Connecting the camera
To adjust the camera angle:
7. Adjust the angle of the camera as needed. Tighten the four screws to secure camera angle.
1. Twist the body of the camera and the base of the camera so that the top and bottom notch align.
Top notch
3 x Mounting Screws
Bottom notch
2. Remove the dome cover.
8. Replace the dome cover. Twist the dome cover so that the top and bottom notches do not align. This locks the dome cover in place.
Connecting The Camera 1. Use the BNC connector to connect camera to a monitor, switch etc. WARNING - A regulated, UL/CSA approved 12V DC power supply is required for use with this camera. Use of a non-regulated, nonconforming power supply can damage this product and will void the warranty.
3. Mark the three mounting holes from the camera base onto the mounting surface.
2. Connect a 12V DC power supply to the camera.
Features: •
High Resolution Image Sensor—produces sharp and clear video
4. OPTIONAL: Secure the drywall anchors into the marked areas of the mounting surface.
•
Fixed IR Fiter provides accurate color reproduction
5. Align the mounting holes and secure the camera in place with the provided screws.
•
3.6 mm lens provides a wide viewing angle
•
Industry standard BNC video connection
6. Using a Phillps screwdriver (not included), slightly loosen the four screws on the support ring.
•
Wall/ Ceiling mountable
ATTENTION - Test all connections and ensure the camera is working correctly prior to permanent installation by temporarily connecting the camera(s) and cable(s) to the viewing/recording solution.
Setup Diagram
