Preview only show first 10 pages with watermark. For full document please download

Vme Table Top Wall Mount&nbsp

   EMBED

Share

Transcript

Contents: Wall Mount Kit for VME Table Top [91800103] Wall Bracket............ 1 Hollow Anchors........ 2 Lag Bolts................. 2 Adhesive Bumpers.. 2 Intended Use: To provide wall mount for a Matrx VME Table Top anesthesia machine. Language of origin: English Caution A qualified installer should install this kit. Mount wall bracket to two wall studs for most secure mounting. A minimum of one wall stud must be utilized. Follow step by step instructions below. Step 1: Install two adhesive bumpers to VME anesthesia machine. Step 2: Mount bracket to wall. Locate wall studs. Use bracket to mark hole locations. Mounting Holes Two Wall Studs Drill a 7/32 hole, 2” deep at each location into wall stud. Fasten wall bracket using two lag bolts. One Wall Stud Drill a 7/16” hole through wall at each of the two outer hole locations. Fasten wall bracket using one lag bolt and two hollow wall anchors. Chase Installation Refer to chase installation manual for mounting hole locations. To install VME use hardware included with chase cabinet. (5/16” bolts, washers and nuts) Step 3: Mount anesthesia machine. Fastening to Two Wall Studs Lag Bolts Bumpers 2.00 17.00 Fastening to One Wall Stud Hollow Wall Anchors Chase Mounting to Chase © 2011 Midmark Corp. | 60 Vista Drive Versailles, OH 45380 USA | 1-800-526-3662 | 1-937-643-6275 | midmark.com Lag Bolt English-1 Style A 10417600 Rev. C (6/12)