Vmicpci-7757

Transcript

VMICPCI-7757 Universal CompactPCI® SBC • • • • • • • • • • • • Intel® ultra low voltage Celeron® 650 MHz processor or Intel low voltage 933 MHz Pentium® III processor Up to 512 Mbyte PC133 SDRAM using one 144-pin SODIMM module Fast Ethernet controller supporting 10BaseT and 100BaseTX interfaces Ultra DMA/100 hard drive and floppy drive controllers with CompactPCI® backplane I/O Two high performance 16550-compatible serial ports Full IEEE 1284 parallel port available via the backplane connectors Two USB ports available via the CompactPCI backplane connectors PICMG® 2.0 Compliant CompactPCI system/peripheral slot PICMG 2.1 R2.0 Compliant high availability hot swap Dual PMC expansion sites Serial port redirection Operating system support for Windows NT®/ Windows® 2000/Windows XP, QNX®, Linux®, VxWorks® Functional Characteristics Microprocessor: The VMICPCI-7757 is based on either the Intel ultra low voltage Celeron processor or low voltage Pentium III processor. The enhanced Celeron processor has 256 Kbyte of on-die L2 cache, while the Pentium III processor has 512 Kbyte of L2 cache. The μFCBGA package processors offer thermal characteristics that are well suited for embedded systems operating over a wide range of temperatures. DRAM Memory: The VMICPCI-7757 accepts one 144-pin SODIMM PC133 module for a maximum memory configuration of 512 Mbyte. BIOS: The VMICPCI-7757 System BIOS and video BIOS are provided in reprogrammable memory. subsystems to analog data for the monitor. The GMCH’s integrated 230 MHz RAMDAC provides resolution support up to 1,600x1,200. Circuitry is incorporated to limit the switching noise generated by the DACs. Three 8-bit DACs provide the RGB signals to the monitor. Ordering Options VMICPCI-7757 AGP graphics controller. A fully functional, integrated 2D/3D graphics accelerator provides pixel processing and rendering with display resolutions of up to 1,600 x 1,200 supported. The video output is provided through the CompactPCI J4 connector. The display function contains a RAM-based Digital-to-Analog Converter (RAMDAC) that transforms the digital data from the graphics and video B C – D E F 0 0 0 A = Processor 0 = 650 MHz Ultra Low Voltage Celeron Processor 1 = Reserved 2 = 933 MHz Low Voltage Pentium III Processor B = SDRAM Memory 1 = Reserved 2 = 128 Mbyte 3 = Reserved 4 = 512 Mbyte 5 = Reserved C = CompactFlash 0 = No CompactFlash 1 = Reserved 2 = 128 Mbyte CompactFlash 3 = 256 Mbyte CompactFlash 4 = 512 Mbyte CompactFlash 5 = 1 Gbyte CompactFlash D = 0 (Options reserved for future use) E = 0 (Options reserved for future use) F = 0 (Options reserved for future use) CompactPCI Rear Transition Utility Board Video Graphic Controller: High-resolution graphics and multimediaquality video are supported on the VMICPCI-7757 by an internal 815E A Apr. 5, 2005 800-657757-000 C VMIACC-0580 The VMIACC-0580 installs in the rear transition area of the CompactPCI backplane and provides access to IDE, floppy, LAN, USB, video and keyboard/mouse functions. The VMIACC-0580 is sold separately. Connector Adapter 360-010050-001 The connector adapter is a 9-pin Micro DB9 to Standard DB9 serial port adapter. The 360-010050-001 connector adapter is sold separately. For Ordering Information, Call: 1-800-322-3616 or 1-256-880-0444 • FAX (256) 882-0859 Email: [email protected] Web Address: www.gefanuc.com/embedded Copyright © 2005 by GE Fanuc Embedded Systems Specifications subject to change without notice. GE Fanuc Automation, Inc. 12090 South Memorial Parkway, Huntsville, Alabama 35803-3308 1 VMICPCI-7757 Sync signals are properly delayed to match any delays from the D/A connectors require the VMIACC-0045 or an individual connector conversion. Associated with each DAC is a 256 pallet of colors. The adapter. The connector adapter is a 9-pin Micro DB9 to Standard DB9 RAMDAC can be operated in either direct or indexed color mode. In serial port adapter. The 360-010050-001 connector adapter is sold direct color mode, pixel depths of 15, 16, or 24 bits can be realized. separately Non-interlaced mode is supported. Gamma correction can be applied to the display output. The GMCH supports a wide range of resolutions, color depths, and refresh rates via a programmable dot clock that has a maximum frequency of 230 MHz. CompactFlash: The VMICPCI-7757 includes a CompactFlash socket on the assembly. The CompactFlash may be configured as the boot device through the BIOS boot device set up. The CompactFlash, as an ordering option is available up to 1 Gbyte of storage space. IDE Interface: The VMICPCI-7757 provides an IDE interface for hard disk drive support. The IDE interface allows support of several types of data transfers: Programmed I/O (PIO), 8237 style DMA, Ultra ATA-33, Ultra ATA-66 and Ultra ATA-100. Ethernet Controller: The VMICPCI-7757 provides a front panel connection to either 10BaseT or 100BaseTX LAN using the Intel 82551ER Ethernet controller. A standard RJ45 connector is provided on Parallel Ports: The VMICPCI-7757 provides a full IEEE 1284 parallel port through the backplane connectors. PMC Expansion Sites: The VMICPCI-7757 provides two individual IEEE 1386.1 5V PCI mezzanine card (PMC) expansion sites. This expansion capability allows the addition of peripherals offered for PMC applications. Keyboard and Mouse Ports: The VMICPCI-7757 supports a PS/2 keyboard and mouse through the CompactPCI J4 connector using the optional VMIACC-0580 backplane adapter. Hardware Reset: A hardware reset switch is accessible from the front panel. Programmable Timer: The VMICPCI-7757 provides the user with two 16-bit timers and two 32-bit timers. These timers are mapped in PCI memory space, are completely software programmable, and can generate PCI interrupts. the front panel with two network status indicators. A second LAN port Watchdog Timer: The VMICPCI-7757 provides a software- supporting both 10BaseT and 100BaseTX is available via the ICH2. The programmable watchdog timer. The watchdog timer is enabled under second LAN RJ45 connector is available on the optional VMIACC-0580 software control. Once the timer is enabled, software must access the rear transition utility board. timer within the specified time period or the output of the watchdog Remote Ethernet Booting: The VMICPCI-7757 integrates the Argon timer will reset the unit. Managed PC BOOT Agent into the ROM BIOS which enables processor Nonvolatile SRAM: The VMICPCI-7757 provides 32 Kbyte of booting from a network server. The facility supports PXE and a variety of nonvolatile SRAM. The contents of the SRAM are preserved when +5V network boot protocols including BOOTP and DHCP (TCP/IP). power is interrupted or removed from the unit. USB Ports: The VMICPCI-7757 provides two universal serial bus (USB) Annunciators: Indicators for the primary IDE interface activity, board ports. The ports are available at the CompactPCI backplane connectors status, +5V power good and a blue LED for hot swap are provided on the J4/J5 with the signals terminating to industry standard USB connectors front panel. In addition, two indicators for the Ethernet adapter activity on the optional VMIACC-0580 rear transition utility board. are located on each RJ45 network connector. Serial Ports: The VMICPCI-7757 provides two 16550-compatible serial Thermal Management: The VMICPCI-7757 utilizes a passive heat sink ports. Each serial port has an independent 16-byte FIFO supporting baud that relies on forced air cooling within the equipment rack at the rates up to 115 Kbaud. Connection for both serial ports is provided by specified flow rate. Please refer to the environmental specifications for two Micro DB9 connectors located on the front panel. The Micro DB9 more information. GE Fanuc Automation, Inc. 12090 South Memorial Parkway, Huntsville, Alabama 35803-3308 2 VMICPCI-7757 CompactPCI Bus Bridge: The VMICPCI-7757 is a universal Power Requirements: CompactPCI SBC supporting applications as both a system slot ULV Celeron Processor: controller or a peripheral slot controller. The PCI-to-PCI bridge interface +5VDC (±5 percent), 200mA, 300mA maximum to the CompactPCI bus is automatically configured to operate as either a +3.3VDC (±5 percent), 3.0A, 5.0A maximum transparent or non-transparent bridge. This implementation is fully +12.0VDC (±5 percent), 5mA, 35mA maximum compliant with CompactPCI Rev 2.1, PCI 2.1, and PCI-to-PCI Bridge -12.0VDC (±5 percent), 1mA, 5 mA maximum Architecture Rev 1.1. High-Availability Hot Swap: The VMICPCI-7757 complies with PICMG 2.1 Rev 1.0 standard for CompactPCI hot swap. The VMICPCI-7757 complies with the high-availability provisions of this standard. The processor may be removed and replaced while the system is operational. Processing can automatically be switched to a backup LV Pentium III Processor: +5VDC (±5 percent), 200mA, 300mA maximum +3.3VDC (±5 percent), 4.5A, 6.0A maximum +12.0VDC (±5 percent), 5mA, 35mA maximum -12.0VDC (±5 percent), 1mA, 5mA maximum SBC that was previously installed in the system. Airflow: Forced air cooling required, 300 LFM minimum CMOS Battery: The VMICPCI-7757 uses a holder that permits field Altitude: Operating, 0 – 10,000 ft. (3,000m) replacement of the CMOS battery. A jumper is used to disconnected the Storage, 0 – 40,000 ft. (12,000m) battery from the circuitry for long-term storage. Back Panel Configuration: The VMICPCI-7757 provides support for several peripherals using the CompactPCI backplane connectors. These signals are routed to the CompactPCI J3, J4 and J5 connectors. This permits connection of the external IDE disk drive, floppy drive, USB, LAN, video, and keyboard and mouse via the VMIACC-0580 backplane Temperature: Operating, -0° to +65° C Storage, -20° to +70° C Humidity: Operating, Relative Humidity 5 to 95%, noncondensing Storage, Relative Humidity 5 to 95%, noncondensing MTBF: Total FiTs = 2336, MTBF = 428, 082.191 adapter. Operating Systems and Software Support The VMICPCI-7757 supports a variety of operating systems including Trademarks Microsoft, Windows and Windows NT are registered trademarks of Microsoft Corporation. Celeron, Intel and Pentium are registered Microsoft Windows NT, Windows 2000, Windows XP, QNX, Linux and trademarks of Intel Corporation. CompactPCI and PICMG are registered VxWorks. trademarks of PCI Industrial Manufacturers’ Group. Other registered ® trademarks are the property of their respective owners. Physical/Environmental Specifications Dimensions: 6U (4HP) single slot Eurocard form factor Height 9.2 in. (233.4mm) Depth 6.3 in. (160mm) Thickness 0.8 in. (20.3mm) GE Fanuc Automation, Inc. 12090 South Memorial Parkway, Huntsville, Alabama 35803-3308 3 VMICPCI-7757 Intel Ultra Low Intel Celeron Ultra Low Voltage Voltage or Celeron or Low Voltage Voltage PentiumLow III Processor Pentium III Processor VMICPCI-7757 J5 IDE PC100/133 PC100/133 SDRAM SDRAM SODIMM SODIMM Intel 82815 Intel 82815 GMCH GMCH Video Graphic Controller Intel 815E Chipset USB1 J4 USB2 FWH FWH 10/100 Ethernet Intel 82801BA Intel 82801BA ICH2 ICH2 IDE LPC CompactFlash CompactFlash IEEE 1284 Parallel Port COM 1 COM 2 J3 National National Semiconductor Semiconductor Super I/O Super I/O Keyboard / Mouse Floppy 32/33 MHz PCI Bus PMC I/O FPGA FPGA Timer, Timer, Watchdog, Watchdog, NVRAM NVRAM Control Control PMC Site 1 PMC Site 1 PMC I/O J2 Hint HB6 Hint HB6 HotSwap PCI HotSwap to PCI BridgePCI to PCI Bridge PMC Site 2 PMC Site 2 10/100 Ethernet Intel 82551 Intel 82551 Ethernet Ethernet Controller Controller J1 NVRAM 32NVRAM KB 32 KB Figure 1. VMICPCI-7757 Functional Block Diagram GE Fanuc Embedded Systems Information Centers Additional Resources USA and the Americas: Huntsville, AL 1 800 322-3616 1 (256) 880-0444 Ventura, CA 1 (805) 650-2111 Greenville, SC 1 (864) 627-8800 For more information, please visit the GE Fanuc Embedded Systems web site at: Europe, Middle East and Africa: Edinburgh, UK 44 (131) 561-3520 Paris, France 33 (1) 4324 6007 www.gefanuc.com/embedded