Transcript
Overview All video traffic detection equipment should include electrical surge suppression that protects components inside the cabinet from electrical events outside the cabinet. Peek Traffic provides this protection with its range of Camera Interface Panels. The CIP provides protection in the event of an externally induced power surge. This suppresses the spikes on the camera cable's coax and power lines at the CIP. This reduces the risk of the spikes affecting the rest of the cabinet components; (e.g. video detector cards, controller, cabinet power supply, etc). Another important function of the CIP is that it provides a connection point to route cabinet power to the Cameras while also providing the connection point needed to route the video from the cameras in the field back to the cabinet. With the CIP mounting location just inside the cabinet, it helps to minimized cabinet clutter and installation time.
www.peektraffic.com
Peek Camera Interface Panel (Six Channel)
Earth Ground
Power supply Cabinet AC+
Cabinet power is routed through a surge suppressor which is wired to a pair of five-position terminal blocks. A terminal block is provided for both AC+ and AC–. A copper ground bus is provided for Chassis ground connections. Camera power can be originated at this panel. A Plexiglas shield provides operator protection from line voltage. The shield can be temporarily removed during wiring and installation. Ordering Information The CIP can be ordered in a number of configurations. It can be fully loaded with either three dual channel video protection devices, (six channels) or any combination of dual or single video protection devices. The individual dual or single channel video protection devices are available from Peek and can be used to customize the CIP configuration, as required. Configuration
Part Number
Cabinet AC-
Cabinet power Electrical surge suppression
Protective Plexiglas shield mounting posts
Terminal block for power distribution to cameras
Power Out to Field Cameras
Cabinet Chassis Ground (Copper ground bus)
Cabinet mounting slots Camera Power and Electrical Connections
Specifications
2 Channel
82-1661-04
4 Channel
82-1661-05
5 Channel
82-1661-06
Clamp voltage............................................... 3 Volts
6 Channel
82-1661-07
Response Time............................................. <1ns
Dual Protection Device
81-1074
Video Connections....................................... BNC
Single Protection Device
81-1073
Peak Current @ 8 x 20us waveform............10kA
Grounding: The CIP mounting plate must be tied to electrical ground for proper operation.
* A standard Peek two year warranty applies to all video products
2906 Corporate Way Palmetto, FL 34221 (941) 845-1200 (800) 245-7660 www.peektraffic.com Peek Traffic Corporation, a Signal Group Company 96-150-rev 5
About Peek Traffic Corporation – Peek’s heritage goes back over 120 years, covering a broad range of quality turnkey traffic control products and services. Throughout the years, Peek’s products have helped to make motorists around the world safer and their travels more pleasant and efficient. This expertise, experience, and breadth of product lines has made Peek one of the most respected and recognized leaders in the traffic control marketplace.
The information contained in this publication is presented for informational purposes only, and while every effort has been made to ensure its accuracy, the information is not to be construed as warranty or guarantee, express or implied, regarding the products or services described herein or their use or applicability. No license is granted by implication or otherwise to any of Peek Traffic’s intellectual property. Peek Traffic reserves the right to alter or revise any of its products or published technical data related thereof at any time without notice.
©2011 Peek Traffic Corporation, a Signal Group Company
