Transcript
i i i i i i i i
Ideal for isolating a typical 4~20mA current loop. Input to Output Isolation 2.5kV. High Accuracy 0.03%. 24Vdc Powered. Reverse Polarity Protected. Compact DIN Rail Mount Enclosure. Easy to Install. Low Cost. MODEL
XID-P1
DESCRIPTION
PRICE
$220.00
One Isolator.
www.intech.co.nz/xid-p
INTECH INSTRUMENTS
XID-P1 24Vdc Powered Isolator
NEW Wireless Z-2400-A2 Series If you are looking for wireless monitoring and/or remote control solutions, Intech’s Z-2400-A2 Series may be the answer. The Intech Z-2400-A2 devices are integrated with ZigBee® technology to form a mesh network between nodes. This technique allows the range of an individual node to be expanded and multiplied, covering a much larger area. When the mesh network discovers a new Z-2400-A2 node, it will automatically incorporate it into the current wireless network. MODEL
DESCRIPTION
W! NE
PRICE
Z-2400-A2IO The Z-2400-A2IO is the kit set of the Input (Z-2400-A2I) and Output (Z-2400-A2O) wireless nodes, supplied as a complete set paired to each other with a unique mesh ID.
$896.00
Z-2400-A2I The Z-2400-A2I is a 2 channel analogue input wireless node, when switched on it
Kit Only
looks for the output node to sends it’s input values to via the wireless link. The inputs are individually programmable as follows:
x x x x x x
RTD: Pt100/Pt1000, -200~800°C. Thermocouple: B, E, K, J, N, R, S, T, with CJC. mA: 0~20mA (4~20mA). mV: -25~25mV to -200~1000mV. V: 0~1V to 0~18V. Pulse/Digital Max speed 1Hz.
It also comes equipped with 4 digital inputs, 2 digital outputs, and 2 relay outputs. Z-2400-A2O The Z-2400-A2O is a 2 channel analogue output wireless node. It acts as the base and
Kit Only
controls it’s entire ZigBee wireless network. Like the input node, it comes equipped with the matching 4 digital inputs and 4 digital/relay outputs. The analogue output is 4~20mA only at 24Vdc. Z-2400-A2R The Z-2400-A2R is quite simply a ZigBee wireless repeater. It is used to boost the signal strength between the other two nodes, input and output, to extend the range. The maximum number of repeater nodes per wireless mesh network is 15. XU-USB
USB Programming Key for programming Z-2400-A2 Series using uP Configure Programming Software (version 1.2.8.0 or later).
Note: The Z-2400-A2I can also be used with the Z-2400 Series as part of a MicroScan SCADA Wireless system.
See pages 34~35 >> $470.00
$88.00
(Same Key as used for programming XU Series transmitters, 2400-A16, Z-2400-Sleeper, IN-uP4 and uP4-Din.) Note: ZigBee® is a Registered trademark of the ZigBee Alliance, Inc.
www.intech.co.nz/z-2400-a2
Antenna Options (Used when greater distances are involved): MODEL
ZA-OD24-5 ZA-BKT01 ZA-OD24-3 ZA-OD24-8 ZA-MD24-12 ZA-PG24-19
DESCRIPTION
ZigBee® Antennas 2.4GHz - for Z-2400-A2 Series. Indoor 5.5dBi Omni Directional Rubber Duck Antenna. Bracket Extension Kit for Z-2400 Indoor Antennas c/w 1m coax cable. Outdoor 3dBi Omni Directional Whip Antenna c/w 0.3m coax cable. Outdoor 8dBi Omni Directional Monopole Antenna c/w 3m coax cable. Outdoor 12dBi Mini Directional Antenna c/w 3m coax cable. Outdoor 19dBi Directional Parabolic Grid Antenna c/w 3m coax cable. Z-2400-A2 Performance (2.4GHz). • Indoor Urban: With Supplied Whip - Up to 100m. • Outdoor Ideal* Conditions:
PRICE
$41.00 $77.00 $74.00 $252.00 $164.00 $252.00
ZA-OD24-5
ZA-MD24-12
ZA-OD24-8
ZA-PG24-19
With ZA-OD24-8 - Up to 1.5km. With ZA-PG24-19 - Up to 8km.
Notes: x *Ideal conditions = mounted on 2 metre pole with line of sight and no surrounding trees or buildings, using supplied coax cable only. x Test results show impressive distance results under ideal line of sight conditions. These distances are rapidly reduced when obstructions to ‘line of sight’ are experienced. x For outdoor antennas, the supplied coax-seal must be used between exposed connections to protect from moisture corrosion. x Use only Intech ZA Antennas with Intech Z-2400-A2 Series wireless modules. All prices are in NZ$, are GST exclusive and are subject to change without notice.
9
INTECH INSTRUMENTS
NEW Wireless MicroScan Connections - ZigBee® Z-2400 Series ZigBee® is a new technology designed for short range mesh networking that allows easy expansion. Ideal for sites where wireless is preferred over cable connections. Applications: Hospitals, Labs, Blood banks and Industry.
New Wireless ZigBee® Technology empowers MicroScan SCADA Example schematic showing MicroScan Software and the 2400-A16 Remote Station plus Sleeper for mobile monitoring: MicroScan Recorder / SCADA
W! E N
Z-2400-TCP-T Ethernet Base module Ethernet
Network Switch/Hub
Ethernet
Z-2400-A2I Input module Z-2400-RB-T Remote module LPN-H-W RS485
Shimaden Controller
2400-A16 Remote Station
Z-2400-Sleeper
Temperature Probes
www.intech.co.nz/zigbee
Allows monitoring of mobile equipment
* 2.4GHz high gain antennas available on page 35 >>
Z-2400 Series Common Specifications: Wireless standard: Wireless range: Wireless Frequency: Frequency Hopping: MODEL
Z-2400-RB-T
IEEE 802.15.4-2006. Up to 100m max line of sight.* 2405~2485MHz. 16 Channels. DESCRIPTION
PRICE
$486.00 For Comms converters Base or Remote Module. with the Z-2400-RB-T (set Communications: RS232, RS422, RS485. | Duty: Configurable as Base or Remote. as Base) see page 21 << Embedded protocol support: MicroScan default ASCII. | Wireless Power: 100mW.
Z-2400-TCP-T Ethernet Base Module. Communications: Ethernet TCP/IP. Embedded protocol support: MicroScan.TCP. Z-2400-A2I
Power supply: 9~36Vdc. Power Consumption: 5 VA. Plug pack power supply included.
$795.00 | |
Duty: Base only. Wireless Power: 100mW.
Input Module. Set as MicroScan mode. Universal channel data inputs: 2x RTD/Tc/mV/V/mA/Pseudo Digital. Digital inputs: 4x 0~1Hz. | Wireless Power: 100mW. Digital outputs: 2x 30Vdc, 1A max. Relay outputs: 2x 250Vac/30Vdc, 5A max.
$448.00
$618.00 Z-2400-Sleeper Sleeper Module. Universal channel data inputs : 2x RTD/Tc/mV/V/mA/Pseudo Digital. Selectable update rate: 1, 2, 5, 15, 30, 60 minutes. Wireless Power: 1mW. Embedded protocol support: MicroScan default ASCII. Battery life: Approx 2 years life when wake up interval set to 2 minutes. Poor signal strength reduces battery life. Option to permanently power with plug pack power supply. Z-2400-BAT XU-USB
Replacement battery for Z-2400-Sleeper.
$38.00
USB Programming Key for programming Z-2400-Sleeper and Z-2400-A2I.
$88.00
(Same Key as used for programming XU Series transmitters, 2400-A16, IN-uP4, uP4-Din and Z-2400-A2 Series).
Note: ZigBee® is a Registered trademark of the ZigBee Alliance, Inc.
34
All prices are in NZ$, are GST exclusive and are subject to change without notice.
Antenna Options (Used when greater distances are involved): MODEL
DESCRIPTION
PRICE
ZB-OD24-5 ZB-BKT01 ZB-OD24-3 ZB-OD24-8 ZB-MD24-12 ZB-PG24-19
ZigBee® Antennas 2.4GHz for Z-2400 Series (not Z-2400-A2I). Indoor 5.5dBi Omni Directional Rubber Duck Antenna. Bracket Extension Kit for Z-2400 Indoor Antennas c/w 1m coax cable. Outdoor 3dBi Omni Directional Monopole Antenna c/w 0.5m coax cable. Outdoor 8dBi Omni Directional Monopole Antenna c/w 6m coax cable. Outdoor 12dBi Mini Directional Antenna c/w 6m coax cable. Outdoor 19dBi Directional Parabolic Grid Antenna c/w 6m coax cable.
$57.00 $77.00 $74.00 $268.00 $180.00 $268.00
ZA-OD24-5 ZA-BKT01 ZA-OD24-3 ZA-OD24-8 ZA-MD24-12 ZA-PG24-19
ZigBee® Antennas 2.4GHz for Z-2400-A2I. Indoor 5.5dBi Omni Directional Rubber Duck Antenna. Bracket Extension Kit for Z-2400 Indoor Antennas c/w 1m coax cable. Outdoor 3dBi Omni Directional Whip Antenna c/w 0.3m coax cable. Outdoor 8dBi Omni Directional Monopole Antenna c/w 3m coax cable. Outdoor 12dBi Mini Directional Antenna c/w 3m coax cable. Outdoor 19dBi Directional Parabolic Grid Antenna c/w 3m coax cable.
$41.00 $77.00 $74.00 $252.00 $164.00 $252.00
Zx-OD24-5 Zx-OD24-8
INTECH INSTRUMENTS
NEW Wireless MicroScan Connections - 2.4GHz High Gain Antennas
Zx-MD24-12 Zx-PG24-19
Z-2400 Performance (2.4GHz). • Indoor Urban: With Supplied Whip - Up to 100m. • Outdoor Ideal* Conditions: With Zx-OD24-8 - Up to 1.5km. With Zx-PG24-19 - Up to 8km.
Notes: x *Ideal conditions = mounted on 2 metre pole with line of sight and no surrounding trees or buildings, using supplied coax cable only. x Test results show impressive distance results under ideal line of sight conditions. These distances are rapidly reduced when obstructions to ‘line of sight’ are experienced. x Use only Intech ZB/ZA Antennas with Intech wireless modules. x For outdoor antennas, the supplied coax-seal must be used between exposed connections to protect from moisture corrosion.
All prices are in NZ$, are GST exclusive and are subject to change without notice.
35
