Transcript
WIRELESS TRANSMITTER-RECEIVER SYSTEM RTD, THERMOCOUPLE, %RH ZGU201 utility for display transmitter date & to process same for data logging or chart display
ZGB201 USB powered receiver which receive date from transmitter
ZGE201 RTD input transmitter
ZGE203 Humidity transmitter
ZGE202 REPEATER-enhances the received signal by increasing its strength and re-sends it.
Headmount enclosure type transmitter for RTD and Thermocouple
ZGE202 thermocouple transmitter
FEATURES Transmitter (Surface and Head Designs) RTD : Pt100 Thermocouple : J, K, T, E, R, S, B, N % RH Range : Up to 120 m outdoor line of sight Up to 40 m indoor / urban Router to extend range Receiver with USB port Free utility software Full-featured SCADA optional Battery life : Minimum 1 year Transmit interval : 2 to 3600 seconds ENQUIRIES Instruments:
[email protected] Sensors:
[email protected] Gauges:
[email protected] Automation:
[email protected] Level:
[email protected]
CAT#507R0
RADIX ELECTROSYSTEMS PVT LTD EL-135/136/137, Electronics Zone TTC Indl. Area, MIDC, Mahape Navi Mumbai - 400 710, India + 91 22 42537777 ·
[email protected]
www.radix.co.in
ZGE201
WIRELESS RTD TRANSMITTER INTRODUCTION ZGE201 is a wireless transmitter used to measure the temperature of a RTD sensor and transmit it to a wireless receiver ZGB201 connected to a PC for data logging.
FEATURES Low power design Pt100 Input Operates in the free radio band 2.4GHz Transmits process temperature, ambient temperature, signal strength & battery status User programmable transmit interval IP65 (NEMA-4X) weather resistant enclosure
SPECIFICATIONS All specifications at ambient of 25 °C, unless specified otherwise INPUT Input type Range limits Accuracy PROGRAMMABLE PARAMETERS* Device ID Transmit interval Computer interface
Range of RF communication Pt100 -200 °C ~ 850 °C ±0.5 for 0~400 °C
1-48 2-3600 seconds USB for programming of parameters
* software utility ZGU202 is included for configuring programmable parameters. DATA TRANSMITTED TO HOST
POWER Battery Battery life Power consumption in sleep mode RF COMMUNICATION RF frequency transceiver carrier RF output power
RF data packet standard MECHANICAL Wall mount Enclosure Dimensions (in mm) Protection Mounting RTD connector
RTD reading, connector ambient temperature reading, RF transmit strength and battery condition
3V lithium 1 year (at 1 minute transmit interval) Below 100uA
ISM 2.4GHz, direct sequence spread spectrum 10dBm (1mW)
Head mount Enclosure Dimensions (in mm)
Up to 120 m outdoor line of sight Up to 40 m indoor / urban IEEE 802.15.4, open communication architecture
ABS plastic 80(L) x 82(W) x 55(H) (without antenna) IP65 (NEMA-4X) weather resistance enclosure Wall/Surface PG7, suitable for cable dia 3 to 6.5 mm or Integral RTD sensor
Protection Mounting RTD sensor
ABS plastic 95(L) x 98(W) x 83(H) (without antenna & integral probe) IP65 Head Integral probe
ENVIRONMENTAL CONDITIONS Operating ambient temperature Relative humidity
0 °C to 50 °C Below 90%, non condensing
ZGE201 www.radix.co.in
ZGE201
WIRELESS RTD TRANSMITTER
ORDERING INFORMATION
SENSOR DRAWING
Sensor Length (L) for Head mount integral sensor
Order Code
A
Construction
B
2550
1
Wall mount enclosure with integral RTD sensor
0
Not applicable
2
Wall mount enclosure with remote RTD Sensor
1
150mm
3
Head mount RTD Sensor
2
300mm
Note1: Sensor input type & sensor length (L) is not applicable for wall mount enclosure. Order code for wall mount enclosure with integral RTD sensor will be 2550-1-0
6
ZGE201 www.radix.co.in
ZGE202
WIRELESS THERMOCOUPLE TRANSMITTER INTRODUCTION ZGE202 is a wireless transmitter used to measure the temperature of a thermocouple and transmit it to a wireless receiver ZGB201 connected to a PC for data logging.
FEATURES Low power design User configurable for type J, K, T, E, R, S, B, N Thermocouple Input Operates in the free radio band 2.4GHz Transmits process temperature, ambient temperature, signal strength & battery status User programmable transmit interval IP65 (NEMA-4X) weather resistant enclosure
SPECIFICATIONS All specifications at ambient of 25 °C, unless specified otherwise INPUT Input type Range limits Accuracy
Thermocouple : J, K, T, E, R, S, B, N Refer table 1 Refer table 1
PROGRAMMABLE PARAMETERS* Input Device ID Transmit interval Computer interface
J, K, T, E, R, S, B, N 1-48 2-3600 seconds USB for programming of parameters
* software utility ZGU202 is included for configuring programmable parameters. DATA TRANSMITTED TO HOST
POWER Battery Battery life Power consumption in sleep mode RF COMMUNICATION RF frequency transceiver carrier RF output power
Range of RF communication RF data packet standard MECHANICAL Wall mount with Remote Thermocouple Enclosure Dimensions (in mm) Protection Mounting Cable entry
Thermocouple reading, connector ambient temperature reading, RF transmit strength and battery condition
3V lithium 1 year (at 1 minute transmit interval) Below 100uA
ISM 2.4GHz, direct sequence spread spectrum 10dBm (1mW)
Head Thermocouple Enclosure Dimensions (in mm)
Up to 120 m outdoor line of sight Up to 40 m indoor / urban IEEE 802.15.4, open communication architecture
ABS plastic 80(L) x 82(W) x 55(H) (without antenna) IP65 (NEMA-4X) weather resistance enclosure Wall/Surface PG7, suitable for cable dia 3 to 6.5 mm
Protection Mounting Thermocouple sensor
ABS plastic 95(L) x 98(W) x 83(H) (without antenna & integral probe) IP65 Head Integral probe
ENVIRONMENTAL CONDITIONS Operating ambient temperature Relative humidity
0 °C to 50 °C Below 90%, non condensing
ZGE202 www.radix.co.in
ZGE202
WIRELESS THERMOCOUPLE TRANSMITTER
TABLE1 RANGE LIMITS
SENSOR / INPUT
TYPICAL ACCURACY WORST CASE ACCURACY AT 30 °C (°C / EU) LOW SCALE HIGH SCALE LOW SCALE HIGH SCALE (°C / EU) RANGE IN WHICH ACCURACY IS SPECIFIED
(°C / EU)
Iron / Constantan (J)
-210
760
0
760
±1
±3
Chromel / Alumel (K)
-270
1372
-50
1200
±1
±3
Copper / Constantan (T)
-270
400
-200
400
±1
±3
Chromel / Constantan (E)
-270
850
0
850
±1
±3
Pt / Pt - 13% Rh (R)
0
1760
400
1760
±2
±5
Pt / Pt - 10% Rh (S)
0
1760
400
1760
±2
±5
Pt - 6% Rh / Pt - 30% Rh (B)
400
1820
400
1820
±3
±5
Nicrosil / Nisil (N)
-270
1300
-50
1200
±1
±3
SENSOR DRAWING
ORDERING INFORMATION Order Code
A
Construction
2572
1
Wall mount enclosure for remote Thermocouple
2
Head mount Thermocouple Sensor
B
Thermocouple input type for C Head mount integral sensor
Sensor Length (L) for Head mount integral sensor
0
Not applicable
0
Not applicable
1
J
1
150mm
2
K
2
300mm
3
T
4
E
5
R
6
S
7
B
8
N
Note1: Sensor input type & sensor length (L) is not applicable for wall mount enclosure. Order code for wall mount will be 2572-1-0-0
6
ZGE202 www.radix.co.in
ZGE203
WIRELESS RELATIVE HUMIDITY & TEMPERATURE TRANSMITTER INTRODUCTION ZGE203 is a wireless transmitter used to measure the Relative Humidity and Temperature and transmit it to a wireless receiver ZGB201 connected to a PC for data logging.
FEATURES Low power design Intergral RH+T sensor Operates in the free radio band 2.4GHz Transmits relative humidity, temperature, signal strength & battery status User programmable transmit interval IP65 (NEMA-4X) weather resistant enclosure
SPECIFICATIONS All specifications at ambient of 25 °C, unless specified otherwise INPUT Sensor type Range limits Normal Maximum ACCURACY Linearity & calibration Temperature effect on accuracy Supply voltage effect Supply ripple effect, 50/60 hz, 5 Vp - p PROGRAMMABLE PARAMETERS* Device ID Transmit interval Computer interface
Capacitive for RH, Semiconductor (Band gap) for temperature 0~100% RH, non-condensing -20~100 °C (-4~212 °F) -40~120 °C (-40~248 °F) (See fig.1)
± 2% RH, ± 0.5 °C ± 0.5% of span / 25 °C ± 0.002% of span / V ± 0.005% of span
1-48 2-3600 seconds USB for programming of parameters
* software utility ZGU202 is included for configuring programmable parameters. DATA TRANSMITTED TO HOST
Relative humidity, temperature, RF transmit strength and battery condition
POWER Battery Battery life Power consumption in sleep mode RF COMMUNICATION RF frequency transceiver carrier RF output power Range of RF communication RF data packet standard MECHANICAL Enclosure Dimensions (in mm) Protection
3V lithium 1 year (at 1 minute transmit interval) Below 100uA
ISM 2.4GHz, direct sequence spread spectrum 10dBm (1mW) Up to 120 m outdoor line of sight Up to 40 m indoor / urban IEEE 802.15.4, open communication architecture
Mounting Humidity sensor
ABS plastic 80(L) x 82(W) x 55(H) (without antenna) IP65 (NEMA-4X) weather resistance enclosure Wall/Surface Intergral sensor
ENVIRONMENTAL CONDITIONS Operating ambient temperature Relative humidity
0 °C to 50°C Below 90%, non condensing
ZGE203 www.radix.co.in
ZGE203
WIRELESS RELATIVE HUMIDITY & TEMPERATURE TRANSMITTER
OPERATING RANGE OF SENSOR Fig 1
100
[%RH]
Maximum operating* conditions
80 60
Normal operating* conditions
40 20 0 -40
[°C]
-20
0
20
40
60
80
100
120
* Normal operating conditions
: RH+T limits for continuous safe use Maximum operating conditions : RH+T limits for use for short periods of time without damage
ORDERING INFORMATION ITEM
MODEL
ORDER CODE
WIRELESS RELATIVE HUMIDITY & TEMPERATURE
ZGE203
2574
ZGE203 www.radix.co.in
ZGB201
WIRELESS RECEIVER INTRODUCTION The ZGB201 wireless receiver is a compact device that receives the transmitted signals from ZGE201, ZGE202, ZGE203 Transmitter & ZGB202 Router and display / log / Graph the data on your PC. ZGU201 software is included with each unit for displaying Process value, Ambient temperature, along with RF signal strength & battery condition.
FEATURES Receive Signal from ZGE201, ZGE202, ZGE203 transmitter & ZGB202 Repeater USB powered Upto 48 channel reception through USB connection ZGU201 windows based software included for display & logging
ORDERING INFORMATION MODEL
ORDER CODE
WIRELESS RECEIVER
ZGB201
2551
SPECIFICATIONS
ITEM
All specifications at ambient of 25 °C, unless specified otherwise
POWER Supply voltage SOFTWARE Computer interface
OS Number of channels RF COMMUNICATION RF frequency transceiver carrier RF output power Range of RF communication RF data packet standard
MECHANICAL Enclosure Dimensions (in mm)
USB-Powered, upto 40mA
USB for programming initial parameters (one interface cable included with receiver) Compatible with Windows 2000, XP, 7, vista 32-bit processor Up to 48 channel
ISM 2.4GHz, direct sequence spread spectrum 10dBm (1mW) Up to 120 m outdoor line of sight Up to 40 m indoor / urban IEEE 802.15.4, open communication architecture
Mounting
Metal 90(L) x 90(W) x 20(H) (without antenna) Wall/Surface
ENVIRONMENTAL CONDITIONS Operating ambient temperature Relative humidity
0 °C to 50 °C Below 90%, non condensing
ZGB201 www.radix.co.in
ZGB202
WIRELESS ROUTER INTRODUCTION The ZGB202 wireless Router is a compact device that receives & retransmit signal to the host.
FEATURES Amplifies weak signal & retransmit to destination
ORDERING INFORMATION ORDER CODE
ZGB202
2552
SPECIFICATIONS
WIRELESS ROUTER
MODEL
All specifications at ambient of 25 °C, unless specified otherwise
ITEM
POWER Supply voltage RF COMMUNICATION RF frequency transceiver carrier RF output power Range of RF communication RF data packet standard
MECHANICAL Enclosure Dimensions (in mm)
5V Eliminator, up to 1A
ISM 2.4GHz, direct sequence spread spectrum 10dBm (1mW) Up to 120 m outdoor line of sight Up to 40m indoor / urban IEEE 802.15.4, open communication architecture
Mounting
Metal 90(L) x 90(W) x 20(H) (without antenna) Wall/Surface
ENVIRONMENTAL CONDITIONS Operating ambient temperature Relative humidity
0 °C to 50 °C Below 90%, non condensing
ZGB202 www.radix.co.in
