Transcript
WMAN Dynamic Range Extender Quick Start Guide Typical Switch Routing Diagram External Switch Matrix (not included) Spectrum/Signal Analyzer
POWER
S1
S2
HIGH VOLTAGE
1
2 3
DRE DOWNLINK OUT
4
2
DOWNLINK
BSE
OUT
DUT
IN
S3 - Polarization
1 1
BI-DIRECTIONAL WARNING
2
Voltage: ~85–264 V 50/60 Hz 260 VA
Dual Polarized Measurement Antenna
Fuse: 3A 250 V T
WMAN Dynamic Range Extender Part #113008
TRIGGER IN
OUT
INVERT
DRE DOWNLINK IN
PWR LED
1301 Arrow Point Drive Cedar Park, TX 78613 USA www.ets-lindgren.com
Cellular Comm Tester RF OUT DRE BI-DIRECTIONAL DUT 1 2
Cellular Comm Tester IN/OUT
Communication Antenna
3 4
With your WMAN Dynamic Range Extender you also receive one BNC cable: Switch Matrix Connections Measurement / Test Measure TIS Measure TRP
Switch / Position S1 S2 1 2 2 1
Safety Information BEFORE POWER IS APPLIED TO THIS INSTRUMENT, GROUND IT PROPERLY through the protective conductor of the AC power cable to a power source provided with protective earth contact. Any interruption of the protective (grounding) conductor, inside or outside the instrument, or disconnection of the protective earth terminal could result in personal injury. USA Headquarters 1301 Arrow Point Drive Cedar Park, TX 78613 Phone: (512) 531-6400
[email protected]
HIGH VOLTAGE: Indicates presence of hazardous voltage. Unsafe practice could result in severe personal injury or death.
ONLY QUALIFIED PERSONNEL should install, operate, or service this equipment.
Please see www.ets-lindgren.com for a list of all ETS-Lindgren offices. WARRANTY
© Copyright 2008 by ETS-Lindgren L.P. All Rights Reserved. No part of this document may be copied by any means without written permission from ETS-Lindgren L.P. The ETS-Lindgren logo is a trademark of ETS-Lindgren L.P.; WiMAX and Mobile WiMAX are trademarks of the WiMAX Forum.
399543, Rev A
Revision: A, Initial Release
|
Date: November, 2008
www.ets-lindgren.com
CONTACT ETS-LINDGREN PRIOR TO SERVICING. Servicing (or modifying) the unit by yourself may void your warranty. If you attempt to service the unit by yourself, disconnect all electrical power before starting. There are voltages at many points in the instrument that could, if contacted, cause personal injury. Only trained service personnel should perform adjustments and/or service procedures upon this instrument. Capacitors inside this instrument may still be CHARGED even when instrument is disconnected from its power source.
www.ets-lindgren.com
WMAN Dynamic Range Extender Quick Start Guide
External Switch Matrix (not included)
Before connecting any components, see Safety Information on the front page of this document.
Front of Rack
Dual Polarized } Measurement Antenna
See Switch Routing Diagram on the back page of this document for typical switch matrix and testing configurations.
Communication Antenna
Back of Rack
POWER
HIGH VOLTAGE
To AC power
BI-DIRECTIONAL
DOWNLINK
BSE
OUT
DUT
IN
WARNING
Voltage: ~85–264 V 50/60 Hz 260 VA
Trigger Polarity Control (Invert) WMAN Dynamic Range Extender Part #113008
Fuse: 3A 250 V T
Input
High
Low
Uplink
Downlink
Downlink
Uplink
Default
TRIGGER IN
OUT
1301 Arrow Point Drive Cedar Park, TX 78613 USA www.ets-lindgren.com
INVERT PWR LED
Inverted
HIGH VOLTAGE
Agilent E6651A Mobile WiMAX™ Test Set
Agilent E6651A Mobile WiMAX™ Test Set
RF IN/OUT
TRIGGER2 OUTPUT
Signal Analyzer Cable Legend
Signal Analyzer
RF cable
RF INPUT
TRIGGER IN
BNC cable Power cable
www.ets-lindgren.com
