Transcript
Part No. 49659 Revised April 2002
Master Pop 6 Oz. Popper
Popcorn Machine Instruction Manual
w
w
w
.fo
od -
se
rv
ic
e. c
om
.u a
Models #2450, #2450D
Cincinnati, OH 45241-4807 USA.
.fo
w
w
w
.u a
om
e. c
ic
rv
se
od -
SAFETY PRECAUTIONS
Master Pop, 6 Oz. Popper
INSTALLATION INSTRUCTIONS SETUP
Your new MASTER POP Popcorn Machine is completely assembled. Remove all packing material and tape before starting operation.
OPERATING INSTRUCTIONS CONTROLS AND THEIR FUNCTIONS
.u a
There are three switches on the popper.
LIGHT AND WARMER SWITCH Turns on the heat light.
om
KETTLE MOTOR SWITCH
Turns on the motor which drives kettle agitator shaft.
KETTLE HEAT SWITCH
e. c
Turns on the kettle heat element
AMOUNT OF POPCORN AND OIL
rv
ic
Your new popper is equipped with a six ounce [177 ml] corn measure cup. We recommend flavored and colored coconut oil. Popcorn popped in coconut oil stays fresh longer. Coconut oil does not leave black deposits in your kettle like other oils.
od -
se
Corn charge - 6 oz. [177 ml] Oil charge - 1.6 to 2.0 oz. [60 ml] Flavacol - 1 tablespoon [8 cc]
POPPING INSTRUCTIONS
Turn KETTLE HEAT and KETTLE MOTOR switch "ON". Make test pop with 3 kernels of corn and 1 oz. [30 ml] of oil. Pour pre-measured popcorn and oil pouch into kettle. When corn has popped, dump kettle. Repeat steps 3 and 4 for additional batches; always pop 3-5 batches for best popcorn.
w
w
w
.fo
1. 2. 3. 4. 5.
3
ALL MODELS #2450
Master Pop, 6 Oz. Popper
CARE AND CLEANING
.u a
Each time you finish a series of poppings, wipe the outside of the kettle with a soft cloth to remove any oil drippage on the outside of the kettle. After you finish popping for the day, allow kettle to cool until it is not too hot to handle, but still warm. With a cloth, wipe out the inside of the kettle, kettle lid, crossbar, outside and underneath of the kettle.
w
w
w
.fo
od -
se
rv
ic
e. c
om
Cleaning the cabinet of your machine is easy. Wipe excess grease from the glass using a clean cloth. Wipe the outside of the machine also. NOTE: Never use a glass or plastic cleaner that contains ammonia. It will crack the plastic on the machine.
4
ALL MODELS #2450
Master Pop, 6 Oz. Popper
ic
e. c
om
.u a
MAINTENANCE INSTRUCTIONS
ACCESSORIES
Part Number
rv
Description
49049 47145 47678
od -
se
Corn Measure Cup A-Scoop Flavacol Cup
.fo
ORDERING SPARE PARTS
w
w
w
1. Identify the desired part by checking it against the photos, illustrations, and/or the parts list. 2. When ordering, please include part number, part name, and quantity desired. 3. Please include your model name and machine serial number (located on the machine nameplate) with your order. 4. Address all parts orders to:
Parts Department Gold Medal Products Co. 10700 Medallion Drive Cincinnati, Ohio 45241-4807 or, place orders at:
(800) 543-0862 (513) 769-7676 Fax: (513) 769-8500 E-mail:
[email protected]
5
ALL MODELS #2450
Master Pop, 6 Oz. Popper
PARTS LIST - CABINET ASSEMBLY
47120 49395 41359 41360 41373 41374 49664 49665 49666 50013
.fo w w
Quantity
e. c
1 3 1 4 4 1 1 1 1 1 2 1 1 1 6 4 1 1 2 1 1 1 4 2 1 3 2 2 2 2 2 1 1 1 2
.u a
om
Lead-in-Cord, 15 Amp Switch, SPST Rocker Type 50 Watt Flood Light, Coated Crutch Tip Glide Old Main Pan Dome Bottom Plate Weldment Hanger Arm Front Glass Side Glass Motor Plate Drive Motor Lamp Holder Rigid Channel Rigid Channel Magnet Drop Panel Rigid Channel Strain Relief Shipping Carton Adjusting Screw Corner Post Corner Post Knob Lid Lift Knob Lid Lift Plex Door NM Hinge LH Female NM Hinge LH Male NM Hinge RH Female NM Hinge RH Male NM Hinge Left Rear Corner Post Right Rear Corner Post Door Stop Magnet
od -
49650
Description
w
25 26 27 28 29 30 31 32 33
22038 42532 42947 49123 49656 49100 49652 49653 49817 49519 49518 49651 49834 49837 49509 49510 67512 49655 49511 76026 49657 49002
ic
47120
22038 42532 42947 49123 49656 49100 49652 49653 49817 49519 49518 49651 49834 49837 49509 49510 67512 49655 49511 76026 49657 49002 49650
rv
24
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23
Model 2450D Part No.
se
Item No.
Model 2450 Part No.
6
ALL MODELS #2450
.
Master Pop, 6 Oz. Popper
w
w
w
.fo
od -
se
rv
ic
e. c
om
.u a
6 Oz. KETTLE ASSEMBLY
7
ALL MODELS #2450
Master Pop, 6 Oz. Popper
PARTS LIST - 6 Oz. KETTLE ASSEMBLY
.u a om
rv
ic
e. c
6 Oz. Kettle Complete Hex Bolt, 3 /8 -16 x ¾" Set Screw, 10-32 x 3 /16 " Spacer, Kettle Conduit Connector, 90° Acorn Nut Thermostat Conduit Connector, Straight Kettle, Plated Kettle Lid Stir Rod Pivot Bar Heat Element, 925 Watt, 120 Volt Shell, Plated Gasket, Kettle Agitator Assembly Element Clamp Agitator Weight Plastic Handle SS Flex Conduit, 17" Long Serrated Hex Nut, #10-24
.
se
49836 20051 41742 42297 46241 46528 76089 47373 49800 49820 49822 49823 49824 49828 49829 49839 49841 49854 76075 82107-17 49363
Description
.fo w w w
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20
Part No.
od -
Item No.
8
ALL MODELS #2450
Master Pop, 6 Oz. Popper
w
w
w
.fo
od -
se
rv
ic
e. c
om
.u a
ELECTRICAL SCHEMATIC
9
ALL MODELS #2450
Master Pop, 6 Oz. Popper
WARRANTY
.u a
WE WARRANT to the original purchaser the Gold Medal equipment sold by us to be free from defects in material or workmanship under normal use and service. Our obligation under this warranty shall be limited to the repair or replacement of any defective part for a period of six (6) months from the date of sale to the Original Purchaser with regard to labor and two (2) years with regard to parts and does not cover damage to the equipment caused by accident, alteration, improper use, volt-age, abuse, or failure to follow instructions.
rv
ic
e. c
om
THIS WARRANTY IS IN LIEU OF ALL OTHER WARRANTIES EXPRESSED OR IMPLIED, AND OF ALL OTHER OBLIGATIONS OR LIABILITIES ON OUR PART, INCLUDING THE IMPLIED WARRANTY OF MERCHANTIBILITY. THERE ARE NO WARRANTIES WHICH EXTEND BEYOND THE DESCRIP-TION ON THE FACE HEREOF. We neither assume, nor authorize any other person to assume for us, any other obligation or liability in connection with the sale of said GOLD MEDAL equipment or any part thereof.
se
The term “Original Purchaser” as used in this warranty shall be deemed to mean that person, firm, association, or corporation who was billed by the GOLD MEDAL PRODUCTS COMPANY, or their authorized distributor for the equipment.
.fo
od -
THIS WARRANTY HAS NO EFFECT AND IS VOID UNLESS THE ORIGINAL PURCHASER FIRST CALLS GOLD MEDAL PRODUCTS COMPANY AT 1-800428-2676 TO DISCUSS WITH OUR SERVICE REPRESENTATIVE THE EQUIP-MENT PROBLEM, AND, IF NECESSARY, FOR INSTRUCTIONS CONCERN-ING THE REPAIR OR REPLACEMENT OF PARTS.
w
w
w
NOTE: This equipment is manufactured and sold for commercial use only.
GOLD MEDAL PRODUCTS COMPANY 10700 Medallion Drive Cincinnati, Ohio 45241-4807 USA
10
ALL MODELS #2450
