Transcript
Main function reference Model No.
Surface mount
X2-VIDEO-210
√
x2security.com
X2 VIDEO 2-WIRE OUTDOOR STATION USER MANUAL Specification Item
Model
Working voltage / current
Designed & Manufactured to meet Australian specifications X2-VIDEO-210 DC15~17V/180mA
Connection
2 wires
Working temperature
- 25℃ ~ + 55℃
Storing temperature
- 40℃ ~ + 60℃
Optional interphone
Any of our 2-wired indoor monitor 630101094003
X2-VIDEO-210
Products introduction Congratulation on the purchase of your new X2 Video security intercom system. Please read these instructions carefully before installing your system and follow all of the directions to ensure proper installation.
Features and parts
1
Refer to the products whenever you call upon your dealer. 2 1.Screw
3
General Feature: Color CCD camera
4
2.Camera 3.Night illumination for camera. (the LED will be light when the unit is under talking or monitor mode, or the surrounding is less 0.5-5 LUX.)
Aluminum panel with stainless steel push button
4.Speaker
2 wired connection without polarity
5.N/A
Open the door by ID card (optional)
6
Weatherproof feature(IP56)
7 8
6.Calling button 7.Calling button LED 8.Resident number / Night illumination 9.Microphone
9
10 To qualify the products to be used well, do not remove cover or back. Refer servicing to qualified service personnel.
11. Red LED/Green LED 12. N/A
11
Reminder: important operation and maintenance (servicing) instructions are contained in this manual.
13 14 15
* The manufacturer reserves the right to change the specification without prior notice.the real products would be a little different from the printing.
10. Lens adjust part (pin hole camera without this part). Use with screwdriver to adjust the lens by up, down, left, right.
13.Talking volume adjust (when the door station's speaker is too louder or lower, adjust this hole. Right for louder, left for lower.) 14. Audio impendence matching adjust (during installation, if the door station's speaker with noise when talking, adjust this hole. Adjust this hole with straight screw driver on left or right until the noise disappear. ) Remark: don't adjust this hole if unnecessary. 15. Connection terminal
