Transcript
XG2138 E1/Datacom BER Tester Datasheet Economical and lightweight, XG2138 combines the testing capabilities of E1, Datacom and IP PING in just one unit. It is used for the performance evaluation of Digital Transmission Network, Digital Data Network (DDN) and some private communication networks, and is intended to meet the demands of equipment installation, engineering verification, daily maintenance, and Ethernet connection. Stat. of packet lose rate
Basic Functions
y
E1 testing
Other functions
y
75Ω and 120Ω line interfaces
y
Error injection: Bit, Code, FAS, CRC
y
HDB3 and AMI line codes
y
LED alarm and status indication
y
Out-of-service 2Mb/s, N×64kb/s BER testing
y
Real-time clock
y
In-service Error testing under HI-Z mode and through mode
y
ITU-T G.821, G.826, and M.2100 performance analysis
y
Timeslot activity monitoring
y
y
E1 Level, Frequency and offset measurements
Test results uploaded, conserved and printed by TestManagerPro software via USB cable connected to PC
y
Clock slip measurement
y
Clock source: Internal, Interface
y
Real-time transmit circuit open/short indication
Main Features y
Handheld design, small in size, portable and easy-to-use
y
High resolution backlit LCD
y
Smart navigation mode displays
y
Unique IP PING function in accordance with the need of telecom data channel development and maintenance
y
Self-check and keyboard testing
y
SYNC BER testing with data rate 1.2Kb/s ～ 38.4Kb/s, Nx64Kb/s（N=1~32）
Extensive error and alarm generation, detection and indication
y
Histogram analysis of alarm and error events
y
SYNC clock source and sense selection
y
Up to 99 days continuance test performance
y
Data interface transmission rate test and offset calculation
y
Save/Recall up to multiple user-defined setups and multiple results
y
Handshaking signals control and monitoring
y
Power-off function
y
Built-in Li-ion rechargeable batteries and smart charger circuit
Datacom testing y
Datacom (V.24, V.35, V.36, X.21, RS-449, RS-485, EIA-530 and EIA-530A) interfaces BER testing
y
DTE or DCE emulation mode
y
ASYNC BER testing with baud rate 50b/s ～ 57.6Kb/s
y
Ethernet PING testing y
Fixed IP PING test
y
Stat. time delay
protection,
support
the
Call-Back
www.xgxc.com
y
Output the test results in form of engineering report or Excel format
y
Upgradeable embedded software
Accuracy：±1ppm Range：-999ppm～+999ppm
Datacom Testing
Configurations
Line Interface
E1/Datacom BER Tester
1set
E1 75Ω Unbalance Test Cable
2pcs
V.24、V.35、V.36、X.21、RS-499、RS-485、EIA530、 EIA530A
E1 120Ω Balance Test Cable
1pcs
Bit Rate
Datacom Adapter Cables
4pcs
Datacom Interface Loop-back Connector
1pcs
ASYNC: 50、75、150、300、600bit/s，1.2、2.4、4.8、 7.2、9.6、19.2、38.4、57.6Kb/s
Ethernet Test Cable
1pcs
USB Communication Cable
1pcs
AC Power Adapter
1pcs
Li-ion Rechargeable Battery (Built-in)
1pcs
TestManagerPro Setup CD
1pcs
User’s Manual
1pcs
Waterproof Package
1pcs
Quality Certificate Card
1pcs
Maintenance Card
1pcs
Packing List
1pcs
Specifications E1 Testing Internal Clock 2048Kb/s ± 10ppm Line Interfaces 75Ω (Unbalance) 120Ω (Balance) High Input Impedance>2KΩ Line Code HDB3, AMI Frame Type Unframed, PCM30, PCM30CRC, PCM31, PCM31CRC Level Measurement Range:-43dB ～ -2.5dB Frequency Measurement Accuracy: ±1Hz Offset Measurement
SYNC: 1.2、2.4、4.8、7.2、9.6、19.2、38.4Kb/s、 N×64Kb/s（ N=1~32）
Ethernet Testing Rate 10/100M compatible Mode Full-duplex Physical Interface RJ-45
Others Test Patterns PRBS: 223-1，215-1，211-1，29-1 Fixed Code: 1111, 0000, 1010 16-BIT: User Programmable Word PRBS Polarity: Normal or Inverted Alarm Indications Signal Loss, AIS, Frame Loss, MFrame Loss, Pattern Loss, Remote Alarm, Error, Clock Slip, Octet Loss, Low Battery Error Insertion Type: BIT, FAS, CODE, CRC4, E-BIT，Single, OFF, Fixed Rate: 10-2, 10-3, 10-4, 10-5, 10-6, 10-7 Performance Analysis ITU-T G.821, G.826 and M.2100 Communication Port Master-slave USB Port Rechargeable Battery 7.4V Li-ion battery, continuous working for 6 hours Recharge Time www.xgxc.com
Approx. 2 hours Power Supply AC Adapter: Input: 100V ~ 240VAC, 50/60Hz Output: 12VDC /1.5A Batteries: 7.4V Li-ion Battery TestManagerPro Software Operating System: WIN98/ME/2000/NT/XP Operating Temperature 0℃～50℃ Storage Temperature -30~+70℃ Humidity 5%~95% non-condensing Dimensions 230mm×72/116mm×46mm (L×W×H) Weight Approx.0.5kg
Ordering Information XG2138
E1/Datacom BER Tester
For more information or a directory from sales offices, please send inquiry to mail address:
[email protected]
© Copyright 2010 XGXC. All rights reserved. All product and company names are trademarks of their corporations. Note: Specifications, terms and conditions are subject to change without notice. www.xgxc.com
