Transcript
SIGNAL PROCESSORS PROFESSIONAL MULTI-EFFECT PROCESSOR
SPX1000
■ GENERAL SPECIFICATIONS Electrical Characteristics Frequency Response Dynamic Range Total Harmonic Distortion
20Hz ~ 20kHz 90dB (Delay Mode) Less than 0.03% at 1kHz
Analog Input Number of Channels Nominal Level Impedance
Unbalanced x 2 (Phone Jack) +4/–20dB Switchable 50kΩ (STEREO IN), 20kΩ (MONO)
A/D & D/A Conversion Number of Channels Sampling Frequency Quantization
2 44.1kHz 16 bits
Analog Output
■ 40 preset effects in ROM, 59 user-stored RAM locations for custom-edited programs. ■ Individual two-band parametric EQ and dynamic filter parameters on each effect program.
Number of Channels Nominal Level Output Impedance
Unbalanced x 2 (Phone Jack) +4/–20dB Switchable 220Ω
Digital Input/Output Format Connector
Yamaha Format (16 bits, 2 channels) 8-pin DIN
Memory
Presets (ROM) User Memory (RAM)
1–40 41–99
MIDI Control
SPX1000 Preset Effect Programs 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14. 15. 16. 17. 18. 19. 20.
REV 1 HALL REV 2 ROOM REV 3 VOCAL REV 4 PLATE REV 5 ECHO ROOM EARLY REF. 1 EARLY REF. 2 EARLY REF. 3 GATE REVERB REVERSE GATE DELAY L, C, R STEREO ECHO STEREO FLANGE A STEREO FLANGE B CHORUS STEREO PHASING TREMOLO SYMPHONIC ADR-NOISE GATE PITCH CHANGE 1
21. 22. 23. 24. 25. 26. 27. 28. 29. 30. 31. 32. 33. 34. 35. 36. 37. 38. 39. 40.
PITCH CHANGE 2 PITCH CHANGE 3 FREEZE 1 FREEZE 2 PAN TRIGGERED PAN DISTORTION MULTI (CHO & REV) MULTI (SYM+REV) MULTI (EXC & REV) PLATE+HALL ER+REV ECHO+REV CHORUS+REV PAN+PAN COMPRESSOR LOW LVL EXPANDER EXCITER STEREO PITCH STEREO FREEZE
PROFESSIONAL MULTI-EFFECT PROCESSOR
SPX990
Program Change (Memory selection), Note ON (Pitch selection), Control Change (Parameter control), Bulk Dump & Load (Memory parameters, program change table, user ER data, system setup data)
Front Panel Control&Keys INPUT LEVEL, PARAMETER UP/DOWN, SCROLL BACK, PARAM, EQ, INT. PARAM, LEVEL, EXT CTRL ASSIGN, STORE, MEMORY UP/DOWN, RECALL, UTILITY, TRIGGER, BYPASS Displays 16-character x 2-line LCD, 7-segment x 2-digit LED, 8-element 2-channel LED Level Meter, 4 Input Mode Indicator LEDs, 3 Digital I/O Mode Indicator LEDs, Foot Controller Jacks x 2
Rear Panel Connectors
Switches
INPUT L/R (Phone Jack x 2), OUTPUT L/R (Phone Jacks x 2), MIDI IN, THRU/OUT (5-pin DIN x 2), DIGITAL I/O (8-pin DIN x 2), TRIGGER 2 ANALOG (Phone Jack), TRIGGER 1 SW (Phone Jack), MEMORY INC/DEC (Phone Jack), BYPASS (Phone Jack) Input Level Switch, Output Level Switch, MIDI THRU/OUT Switch, TRIGGER 2 ANALOG Level Switch
Dimensions (WxHxD) Weight
480 x 45.2 x 315mm (18-7/8" x 1-3/4" x 12-3/8") 3.7kg (8.2 lbs.)
* “Aural Exciter” is a registered trademark and is manufactured under license from Aphex System, Ltd.
■ GENERAL SPECIFICATIONS Electrical Characteristics Frequency Response Dynamic Range Ham. and Noise Distortion
20 Hz ~ 20 kHz, ±0.5 dB Above 100 dB (Typical 106 dB) Below –82 dBm (Typical –88 dBm) Below 0.005% at max. level 1 kHz
Input Number of Channel Nominal Level Highest Input Impedance
2 (Phone Jack) +4/–20 dBm (Switchable) +24 dBm (Switchable at +4 dB) 20 kΩ
Output
■ A wide selection of professional-quality digital effects. ■ True stereo (2-In/2-Out) configuration.
■ EFFECT CONFIGURATION
Number of Channel Nominal Level Highest Output Impedance
2 (Phone Jack) +4/–20 dBm (Switchable) +18 dBm (Switchable at +4 dB) 150 Ω
A/D, D/A Conversion A/D Conversion D/A Conversion Sampling Frequency
20 bits 20 bits 44.1kHz
Memory Preset Program User Memory Program Optional Memory Card
1–80 1–99, 00 1–99, 00
MIDI Control Program Change Note on Control Change Bulk Dump
Memory Select Pitch Select Parameter Control Parameter Dump, Program Change Table, System Setup Data
Power Requirements U.S. & Canadian models: British model: General model:
AC 120V, 60 Hz AC 240V, 50 Hz AC 230V, 50 Hz
Power Consumption Dimensions (WxHxD)
25 W
Weight Options
4.6kg (10.1 lbs.)
480 x 46 x 324.4mm (18-7/8" x 1-13/16" x 12-3/4") (including attachment) Memory Card MCD32 Foot Switch FC5
* “Aural Exciter” is a registered trademark and is manufactured under license from Aphex System, Ltd.
47
