Transcript
Flexible Fiber Span with Time Slot Assignment and VLAN functions
YG32 0AF Descripton YODA's YG320AF is a flexible TDM accessed multiplexer enabling transport of data and voice services across carrier's telecom network. YG320AF's modular design with its multiple selection of user interface, has the flexibility to transmit, drop and insert any of Nx64Kbps user signal. Moreover, Featuring with FE1 electrical interface, the YG320AF could connect directly to PBX or any digital data network's FE1 link, while the 10/100Base-T Ethernet interface provides high speed LAN to LAN connectivity. YG320AF incorporates all the advantages of fiber optic, enabling interference immunity, electrical isolation and spanning the electrical signal on multi-mode or single mode fiber for distance up to 2 Km and 40 Km respectively. The LED indicators on front panel are intended for monitoring fiber and electrical interface signals, while the test button performs local and remote diagnostic loopback.
Features E1 complies with ITU G.703 and G.704 Support LAN,V.35 and FE1 interfaces simultaneously for various applications E1 EOC channel access for remote DSU/CSU management Support port based VLAN Support VLAN tag inserting and removing Transparent MAC Address forwarding Support long packet length up to 1522 bytes Yoda Communications, Inc. www.yoda.com.tw 2F, No. 3-1, Industry East Road IX, Science Based Industrial Park, HsinChu, Taiwan Tel:+886-3-563-2323 Fax:+886-3-563-6420
Support Layer 2 Ethernet bridge with Mac address filtering Support ASCII terminal management Support DIP switch setting Nx64K drop and insert, multiplexing and de-multiplexing capabilities Performs test pattern generation and detection Performs local and remote loop back Support V.54 in-band loop back control on fiber, FE1 and V.35 ports Support optional LCD display Optical to electrical signal conversion Single /Multi mode optical transmission Single mode operation up to 40 Km Multi mode operation up to 2 Km Standard SC Duplex connector [Default];PC/FC[optional] connector
Specification FE 1 E lec tri cal Int erf ace Standard: ITU-T G.703 Framing: G.704, Support PCM31, PCM31C, PCM30, PCM30C and unframed Impedance: 75 Ohm or120 Ohm Balanced Line Code: HDB3 V. 35 Ele ctr ica l In ter fac e Interface: V.35/DCE Data rate: Nx64Kbps, N=1 to 32 Timing: Internal, DTE or E1 Connector: DB25 female connector with DB25 to M34 conversion cable Et her net In ter fac e Standard: IEEE 802.3 Ethernet: 10/100 Mbps, Full/Half Duplex, auto-sensing and auto-MDIX Link Data Rate: Nx64Kbps, N=1 to 32 Support long Ethernet packet length up to 1522 bytes Mac Address table: up to 2048 MAC address Connector: two RJ-45 interface ports QoS: Support port based VLAN Yoda Communications, Inc. www.yoda.com.tw 2F, No. 3-1, Industry East Road IX, Science Based Industrial Park, HsinChu, Taiwan Tel:+886-3-563-2323 Fax:+886-3-563-6420
Fi ber In ter fac e Link rate: 2.32 Mbps Wavelength: 1310nm Connector: SC Duplex connector [Default]; PC/FC [optional] Fiber: Single/Multi mode Distance: 2Km for multi-mode, 40Km for single mode Ma int ena nce Test pattern generation and detection Local and remote loop back Support V.54 in band loopback control RS-232C ASCII terminal for craft interface Form C Dry relay outputs for alarm management Ph ysi cal Di men sio n Length: 155.5mm Width: 234.4mm Height: 44.2mm Po wer AC Voltage: 165VAC ~ 265VAC Frequency: 50/60Hz +/-2% Consumption: 5W Fuse: 0.5A DC Voltage: -36VD ~ -72VDC Consumption: 5W Fuse: 0.5A
Yoda Communications, Inc. www.yoda.com.tw 2F, No. 3-1, Industry East Road IX, Science Based Industrial Park, HsinChu, Taiwan Tel:+886-3-563-2323 Fax:+886-3-563-6420
Ordering According to power supply and user DTE interface configured, customer could use the following information to order 1 to 3 different user DTE interfaces and the power mode requested. Ordering statement: Y G32 0AF /i1 /i2 /i3 /M/ P i1 specify the first user DTE interface V for V.35 interface X for no V.35 interface i2 specify the second user DTE interface L for LAN interface X for no LAN interface i3 specify the third user DTE interface F for FE1 interface X for no FE1 interface M specify fiber optic operation mode MM for multi-mode SM for single mode P specify the power supply mode D for DC power input A for AC power input DA for DC+AC input
Yoda Communications, Inc. www.yoda.com.tw 2F, No. 3-1, Industry East Road IX, Science Based Industrial Park, HsinChu, Taiwan Tel:+886-3-563-2323 Fax:+886-3-563-6420
