Transcript
Zoom Pet User Guide
HU88-ZP-ZA hoover.za.com Version 1.0
GENERAL SAFETY INFORMATION 3
2 MACHINE OVERVIEW
FOR HOUSEHOLD USE ONLY.
This vacuum cleaner is intended for household use only and NOT for commercial or industrial use. Handle Carry Handle 2-in-1 Crevice Tool & Dusting Brush HEPA Filter (hidden) Separator Dirt Container Brushbar Height Adjuster Hard Floor Adaptor Cord Guide Hose Guide Hose Cord Wraps On/Off Button 2-in-1 Crevice Tool and Dusting Brush Turbo Tool
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15
Unit
When using the vacuum cleaner basic safety precautions should always be observed, including the following: • Only use the vacuum cleaner indoors on dry surfaces.
1 9
• Turn off the on/off switch on the vacuum cleaner controls before disconnecting or connecting from the mains supply. 10
• Always unplug the vacuum cleaner before connecting or disconnecting the vacuum hose and accessories. • Children should be supervised to ensure that they do not play with the appliance. • This appliance is not intended for use by children under eight years of age and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance in a safe way and understands the hazards involved.
15 11
2
12
3
• Cleaning and maintenance shall not be made by children without supervision. • The appliance should only be used as described in this user guide.
4
• Only Hoover recommended attachments should be used with this appliance.
5
• Do not use this vacuum cleaner if it has been dropped, damaged, left outdoors or dropped into water. Do not use this vacuum cleaner with a damaged cord or plug.
6 13 7 8
• Do not pull or carry this appliance by the cord. Do not use the cord as a handle, close a door on the cord or pull the cord around sharp edges or corners. Do not run the vacuum cleaner over the cord. Keep the cord away from heated surfaces. • Do not handle the plug or the vacuum cleaner with wet hands. • Keep hair, loose clothing, fingers and all parts of the body away from openings and moving parts. • Do not pick up any hot coals, cigarette butts, matches or any hot, smoking or burning objects. • Do not pick up any flammable or combustible materials (lighter fluid, petrol, kerosene etc.) or use in the presence of explosive liquids or vapours. • Do not vacuum up harmful or toxic material (chlorine, bleach, ammonia, drain cleaner etc.).
Filters & Accessories
• Do not vacuum up hard or sharp objects such as glass, nails, screws, coins etc. • Store the vacuum cleaner in a cool, dry area. 14
15
• Use only CB approved 13 amp extension cords. Non-approved cords may overheat. Care should be taken to arrange the cord so that the cord cannot be tripped over. • Do not put any objects into openings. Do not use with any openings blocked and do not restrict airflow. Keep all openings free of dust, lint, hair or anything that might reduce airflow. • Do not use without all of the filters in place. • Take extra care when positioning the vacuum cleaner on the stairs.
NOTE: Some parts may vary according to model. Please check inside flap of box for more details.
PLEASE KEEP INSTRUCTIONS FOR FURTHER USE.
OPERATION 5
4 OPERATION CAUTION: Always switch off the vacuum cleaner before connecting or disconnecting the hose/ attachments, or removing and emptying the dirt container.
Using your machine
IMPORTANT: The vacuum cleaner is equipped with a thermal cut-out. If for any reason the vacuum cleaner does overheat the thermostat will automatically turn the vacuum cleaner off. If this happens, switch the vacuum cleaner off and unplug. Remove and empty the dirt container also check the vacuum cleaner for blockages. Allow the vacuum cleaner to cool for approximately 1 hour (if you have cleaned the filters please wait 24 hours for the filters to fully dry before putting back into the machine). If the vacuum cleaner is blocked, switch off and unplug before removing the blockage. Familiarise yourself with these home maintenance tasks as proper use and care of your cleaner will ensure continued cleaning effectiveness. Assembling your upright
Plug vacuum cleaner into the mains, switch on.
Turn brushbar height adjuster dial to desired setting.
Press the On/Off button to switch on.
Place foot on floorhead and pull handle backwards to recline.
IMPORTANT: Always switch off the vacuum cleaner before disconnecting or connecting the hose and accessories. The accessories can be attached directly to the hose. This vacuum cleaner is fitted with a constantly rotating brushbar. To avoid damage to your flooring, ensure the brushbar is raised to the highest setting when using the accessories. Using the accessories Using a crosshead screwdriver, remove the screw from the back of the vacuum cleaner.
Slide the handle down into the main body of the vacuum cleaner.
Return the screw and tighten, securing the handle into the main body of the vacuum cleaner.
Twist lower hose Choose an accessory. connector anti-clockwise to unlock. Pull and remove lower hose.
Attach TurboTool connector to hose before attaching TurboTool (some models only).
Attach accessory to hose.
2-in-1 crevice tool and dusting brush Line up tabs on the upper hose connector with the tabs in the upper hose entry point. Twist connector clockwise until clicks and locks into place.
Wrap the hose over the hose guide. Line up tabs on the lower hose connector with the tabs in the lower hose entry point. Twist connector clockwise and lock into place.
Place the 2-in-1 crevice tool and dusting brush into the tool holder.
To use the dusting brush, press the tab and slide the dusting brush forwards until it clicks into place.
MAINTENANCE 7
6 OPERATION CAUTION: This vacuum cleaner has a constantly rotating brushbar. When cleaning on stairs raise the height adjuster dial to the highest setting. The brushbar must over hang the stair tread. Always take extra care when cleaning stairs.
Emptying the dirt container
Using on the stairs TIP: Don’t over fill the dirt container to avoid blocking the air flow through the vacuum cleaner and replace filters every 6-9 months. Press the dirt container Hold the dirt container release button, pull and over a bin. Pull the dirt remove dirt container. release clip, allowing dirt/debris to fall out. Hold vacuum cleaner with brushbar over tread of stairs.
Cleaning the pre-motor filter
Use the hard floor setting for best results on hard floors.
Turn the separator Lift the pre-motor Turn the dirt container clockwise to remove from filter out of the lid anti-clockwise to central separator. unlock and lift to remove. the dirt container lid.
40 C max
Tap excess dirt from the filter and rinse under a tap.
24hr
Leave the filter to dry for at least 24 hours.
MAINTENANCE 9
8 MAINTENANCE IMPORTANT: Unplug and switch off vacuum cleaner before performing maintenance or troubleshooting checks. Removing debris from the brushbar
Cleaning the separator
Tap separator over Turn the separator Turn the dirt container clockwise to remove from a bin to remove lid anti-clockwise to any dirt/debris. unlock and lift to remove. the dirt container lid.
Using a soft brush clean any dirt/debris out of the separator.
Removing a blockage from the hose
Re-fitting the pre-motor filter and separator
Slide the pre-motor filter Line up tabs on into the central separator. separator with tabs in dirt container lid. Turn clockwise until separator clicks into place.
Using a pair of scissors remove any threads or hair caught around the brushbar.
Line up the dirt container lid with the dirt container Turn the dirt container lid clockwise to lock.
The separator should sit on seal in bottom of dirt container when correctly fitted.
TIP: To test for a blockage in hose, drop a small ball of paper through the hose. The paper will drop through if the hose is clear. Twist upper hose Twist lower hose connector anti-clockwise connector anti-clockwise and remove upper hose. to unlock. Pull and remove lower hose.
Remove any blockage by inserting wire coat hanger into hose.
Replacing the belt
Cleaning the post-motor filter 24hr
Lift to remove post-motor filter.
Remove any dirt/debris. Leave to dry for 24 Rinse under water hours or until fully dry (max 40°C). before placing back in the vacuum cleaner.
IMPORTANT: Don’t use your vacuum cleaner without all of the filters in place.
Lie vacuum cleaner on its Lift to remove brushbar back exposing brushbar. cover from base of Use a crosshead vacuum cleaner. screwdriver to remove 6 screws.
Lift to remove brushbar. Remove and dispose of old belt. Clean any debris from spindle and place new belt onto spindle.
Place belt on rounded area of brushbar without bristles. Line up right side of brushbar with base, push into place. Lift and push left side of brushbar until clicks into place.
IMPORTANT: If the brushbar does not rotate easily then the belt may not have been fitted correctly. Make sure the belt is not twisted.
10 FAQs
WARNING: To reduce the risk of personal injury, unplug the vacuum cleaner before performing maintenance/troubleshooting checks.
WARRANTY 11 Please affix proof of purchase/receipt here In the event of a claim under warranty this receipt must be produced.
WARRANTY
Is there an accessory missing? • Check the ‘Machine Overview’ page in this guide or the box that the machine came in to make sure that the part is definitely included in your unit.
Why does the vacuum cleaner have no power? •
The plug may not be fully pushed into the electrical socket.
•
Check the fuse in the plug if this needs replacing, always replace with a 13amp fuse.
•
The motor thermostat may have tripped. If this has happened, unplug the vacuum cleaner. Remove and empty the dirt container and check the hose for blockages. Clean the filters and allow the vacuum cleaner to cool for approximately 1 hour (if you have washed the filters you will need to wait 24 hours for the filters to fully dry before putting them back into the vacuum cleaner).
Why won’t the vacuum cleaner pick up? •
There may be a blockage in the hose. Please remove the hose from the vacuum cleaner, check and clear any blockages. Go to ‘Maintenance’.
•
Empty the dirt container and clean filters. Go to the ‘Operation’.
•
The brushbar may not be turning. Go to ‘My brushbar isn’t turning?’ below.
•
The brush bar height adjuster dial may not be set to the correct setting. Go to ‘Operation’.
•
If the accessory/tool will not pick up, check and clear any blockages. Go to ‘Maintenance’.
My brushbar isn’t turning? •
The brushbar may be clogged, check the brush bar and clear any hair or debris. Go to ‘Maintenance’.
•
The belt might be broken, go to ‘Maintenance’.
1. Home of Living Brands (Pty) Limited warrants to the original purchaser of this product (“the customer”) that this product will be free of defects in quality and workmanship which under normal personal, family or household use and purpose may manifest within a period of 1 (one) year from the date of purchase )”warranty period”). 2. Where the customer has purchased a product and it breaks, is defective or does not work properly for the intended purpose, the customer must notify the supplier from whom the customer bought the product (“the supplier”) thereof within the warranty period. Any claim in terms of this warranty must be supported by a proof of purchase. If proof of purchase is not available, then repair, and/or service charges may be payable by the customer to the supplier. 3. The faulty product must be taken to the supplier’s service centre to exercise the warranty. 4. The supplier will refund, repair, or exchange the product in terms of this warranty subject to legislative requirements. This warranty shall be valid only where the customer has not broken the product himself, or used the product for something that it is not supposed to be used for. The warranty does not include and will not be construed to cover products damaged as a result of disaster, misuse, tamper, abuse or any unauthorised modification or repair of the product. 5. This warrant will extend only to the product provided at the date of the purchase and not to any expendables attached or installed by the customer. 6. If the customer requests that the supplier repairs the product and the product breaks or fails to work properly within 3 (three) months of the repair and not as a result of misuse, tampering or modification by or on behalf of the customer, then the supplier may replace the product or pay a refund to the customer. 7. The customer may be responsible for certain costs where the products returned are not in the original packaging, or if the packaging is damaged. This will be deducted from any refund paid to the customer.
HOME OF LIVING BRANDS (PTY) LTD (JOHANNESBURG) JOHANNESBURG
TEL NO. (001) 490-9600
CAPE TOWN
TEL NO. (021) 552-5161
DURBAN
TEL NO. (031) 792-6000 www.hoover.za.com
12 OTHER INFORMATION Service and Help To find your nearest Hoover retailer, simply visit hoover.za.com
Consumables For information on spares and accessories, please visit hoover.za.com The use of genuine Hoover spare parts helps to maintain optimised performance and validates your guarantee.
Technical Specification Voltage: Wattage: Capacity: Cord length: Weight: Subject to technical
220-240V ~ 50/60Hz 1600W 2.4L 7m 4.7kg change without notice.
EEC Statement of Compliance Manufacturer/EEC importer: Hoover, hereby on our own responsibility, declare that the HU88-ZP-ZA Hoover is manufactured in compliance with the following CE Directives: Safety: 2006/95/EC Low Voltage Directive EMC: 2004/108/EC Electromagnetic Compatibility Directive
Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist. Check with your Local Authority or retailer for recycling advice.
NOTES 13
14 NOTES
NOTES 15
HU88-ZP-ZA hoover.za.com
